Sharp DM 2010 Operation Manual - Page 27

MAKING COPIES Interrupting a copy run INTERRUPTING A COPY RUN INTERRUPT is used to interrupt a long copy run so that another job can be done. ● If sort or group copying is being performed, sort or group cannot be selected during interrupt copying. (Sort and group can be performed only if an optional electronic sortring kit and an optional SPF are installed.) 1 Press the INTERRUPT key. ● The copier will return to the initial settings. ● If this copier has been programmed in the auditing mode using user program No. 10, "---" will appear in the copy quantity display. Enter your account number using the numeric keys. The number of copies of the interrupt copying will be accumulated against this account number. See page 13. ● When an optional SPF is being used, the copier will stop after completing the copying of the original which has been fed into the SPF. 2 When the copier stops place an original for interrupt copying on the original table or remove any remaining originals on the SPF and replace with originals for interrupt copying via the SPF. 3 Select the desired available copier functions. 4 Set the number of copies. 5 Press the START key. ● The interrupt copies will be offset from the previous copies when user program No. 19 is enabled. 6 When all INTERRUPT copies are finished, press the INTERRUPT key again to cancel the INTERRUPT mode, and remove the original used for interrupt copying. ● The previous copy quantity, copy ratio, copy density, and paper size will be automatically restored. 7 Replace the original(s) for the interrupted job on the original table or in the SPF and press the START key. 25