Sharp DT 100 DT-100 Operation Manual - Page 26
Connecting to a Computer - projector manual
![]() |
UPC - 074000364684
View all Sharp DT 100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Connecting to a Computer When connecting a computer, ensure that it is the last device to be turned on after all the connections are made. Ensure that you have read the operation manuals of the devices to be connected before making connections. To audio output terminal To RGB output terminal Computer Supplied accessory To INPUT1 terminal To AUDIO (INPUT1, 2) terminal * ø3.5 mm stereo or mono audio cable (commercially available or available as Sharp service part QCNWGA038WJPZ) RGB Cable (commercially available) * When using the ø3.5 mm mono audio cable, the volume level will be half of when using the ø3.5 mm stereo audio cable. Note • See page 54 "Computer Compatibility Chart" for a list of computer signals compatible with the projector. Use with computer signals other than those listed may cause some of the functions to not work. • A Macintosh adaptor may be required for use with some Macintosh computers. Contact your nearest Macintosh Dealer. • Depending on the computer you are using, an image may not be projected unless the computer's external output port is switched on. (e.g. Press "Fn" and "F5" keys simultaneously when using a SHARP notebook computer). Refer to the specific instructions in your computer's operation manual to enable your computer's external output port. Connections 25
![](/manual_guide/products/sharp-dt-100-dt100-operation-manual-bd57dcc/26.png)