Sharp DV-RW550U Operation Manual - Page 38
Timer recording cont'd
![]() |
View all Sharp DV-RW550U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
Recording Timer recording (cont'd) Notes on Timer Recording Both DVD and VCR DVD • If there is a power failure or the unit has been unplugged for more than 1 minute, the clock setting and all timer settings will be lost. • If a programmed start and end time are the same, the recording will be set for 24 hours automatically. • If a start time is earlier and an end time is later than the current time, the recording will start right after you press T-SET. • If a disc becomes full during timer recording, the unit turns itself off. In such case, press T-SET. Insert a new disc. And then press T-SET again to resume the timer recording. VCR • If a tape reaches the end during timer recording, the unit automatically ejects the tape. In such case, insert a new tape to resume the timer recording. Limited Functions during Timer Recording Cancelling the Timer stanby mode. Both DVD and VCR Timer Recording is in Standby • Press T-SET. • You cannot use any functions for either component (even after a timer recording on one component has already began). Either DVD or VCR OR • You cannot change output mode or use SETUP while the other component is in timer standby. • You can turn on the side of the unit that is not in timer standby by pressing POWER, however you cannot use SETUP or change output mode.You only can play or make a basic recording while the other component is in timer standby. Cancelling the Timer Recording. Both DVD and VCR Either DVD or VCR OR Timer Recording is in progress • Press STOP C on the front panel of the Timer Recording side (VCR or DVD). • The timer recording cannot be performed in DVD and VCR at the same time. If you make two programmings withe the same channel and time in both components, the program with a lower program number will be recorded. • You cannot change channels. Other Situations • If a basic recording or an OTR is in progress on one component (e.g.VCR) and the timer recording set for the other component (e.g. DVD) is about to begin, the unit automatically switches to the programmed channel 2 minutes before the programmed starting time, and the recording in progress (for VCR) will be cancelled UNLESS their recording channels are the same. If their recording channels are the same, the timer recording (for DVD) will start without cancelling the recording currently in progress (on the VCR). In this case, a recording of the same channel will be made on both DVD and VCR. 38
![](/manual_guide/products/sharp-dvrw550u-operation-manual-82bea2d/38.png)