Sharp FP-N60CX FP-N60CX Operation Manual - Page 16

OPERATION For the first 30 seconds after the power plug is inserted into the wall outlet, the unit will check the condition of the air. If operation is set to ON during this time, the CLEAN-SIGN LIGHT will alternately flash green, orange and red. MAIN UNIT OPERATION Main Unit Controls • AUTO • SILENT • MEDIUM • HIGH • MAX • POLLEN Plasmacluster Indicator Light Plasmacluster AUTO SILENT MED HIGH MAX POLLEN OFF TIMER h FILTER CLEAN-SIGN MODE-ON / OFF Button The unit will start operating when the MODE-ON / OFF Button is pressed. The unit will begin operating in the AUTO Mode. (fan level) • While operating the Plasmacluster Indicator Light will be on. To switch operating controls, press the MODE-ON / OFF Button until the desired control is activated. (Your desired control will have its Indicator Light lit.) For the best results of the room environment, set your operation control as desired. Stop AUTO operation The fan level is automatically switched (HIGH, MEDIUM, SILENT) depending on the amount of impurities in the air. The sensors detect the impurities for efficient air purification. SILENT operation The unit will operate quietly using minimal air intake. POLLEN mode operation The unit will operate at High level for 10 minutes, then will alternate between MEDIUM and HIGH. 10 minutes: High fan level 20 minutes: Medium fan level 20 minutes: High fan level MEDIUM to MAX operation The unit will operate at a fan level of MEDIUM, HIGH or MAX. E-14