Sharp FP-N60CX FP-N60CX Operation Manual - Page 17

ENGLISH REMOTE CONTROL OPERATION • When you press the POWER ON/OFF Button, a short beep will sound and operation will start. As the initial operation mode, it automatically goes to the AUTO (Fan level) and AUTO Plasmacluster ion Mode. • To stop operation, press the POWER ON/OFF Button again. A long beep will sound and operation will stop. Operations available with the Remote Control • AUTO • MANUAL • POLLEN • OFF TIMER • DISPLAY ON/OFF Plasmacluster ion mode selections • AUTO • CLEAN • ION CONTROL • OFF POWER ON/OFF Button Transmitter Used to start AUTO operation of the unit. A short beep will signal that the unit is on and a long beep means that the unit is off. Auto (Fan Level) Button The fan level switches automatically depending on the amount of impurities in the air. Manual (Fan Level) Button The fan level can be switched between Silent, Medium, High and Max. Display ON/OFF Button Switches the Plasmacluster Indicator Light and CLEANSIGN Light either ON or OFF. • The Plasmacluster Indicator Light is turned on for about 3 seconds by pressing the Plasmacluster Ion Select Button (except for the OFF Button) during "Display OFF" mode. POWER ON/OFF FILTER RESET Fan Control AUTO MANUAL POLLEN OFF TIMER DISPLAY ON/OFF Plasmacluster CLEAN AUTO OFF ION CONTROL Filter Reset Button When you have cleaned the Washable Active Carbon Filter and re-inserted into the main unit, press the Filter Reset Button with an instrument with a point such as a pen. Pollen Mode Operation Button The unit operates effectively when you suspect there is pollen in the air. See Page E-14 Off Timer Button Used to set the Off Timer. The set time switches every time the button is pressed as shown below. 1 hour Cancel 4 hours 8 hours • The indicator light shows the remaining time. • The unit will cease operating when the timer is up. Plasmacluster Ion mode Selections Auto When pressed, the unit will switch between Clean Mode and the Ion Control Mode automatically depending on the amount of impurities in the air as detected by the dust and odor sensors. Clean Mode will operate for about 1 minute when the Auto function is selected. Clean When pressed, the unit will constantly operate in the Clean Mode, in which the same numbers of positive and negative ions are discharged. (The Plasmacluster Indicator Light is blue.) Ion Control When pressed, the unit will constantly operate in Ion Control Mode. Ion balance is maintained in the room environment by increasing the ratio of negative ions. (The Plasmacluster Indicator Light is green) Off The generation of ions will cease and the Plasmacluster Indicator Light will go out. If the room is damp or has a mold problem, operate the unit in Clean Mode. E-15