Sharp FPP60CX FP-P60CX Operation Manual - Page 20

TROUBLESHOOTING Before calling for repair, please review the list below, since the problem may not be a unit malfunction. SYMPTOM REMEDY (not a malfunction) The Remote Control does not work • Have the batteries been depleted? • Are the batteries inserted correctly? • Is a fluorescent light in the room flickering due to service life? Odors and smoke are not removed The CLEAN-SIGN Light illuminates green even when the air is impure • Clean or Replace the filters if they appear to be heavily soiled. (Refer to E-16,E-17) • The air could be impure at the time the unit was plugged in. (Refer to E-13) Pull out the plug from the electrical outlet, and insert the plug one minute later. The CLEAN-SIGN Light illuminates orange or red even when the air is clean • The sensitivity of the sensor becomes unstable when the opening of the odor sensor is dirty or is clogged. Clean the dust around the sensor opening using a vacuum cleaner. (Refer to E-15) The Plasmacluster Indicator Light remains green (or blue) and does not change • When in Ion Control Mode ( or Clean Mode), the Plasmacluster Indicator Light color will not change. A clicking or ticking sound is heard from the unit • Clicking sound or ticking sound is emitted when the unit is generating ions. The discharged air has an aroma or odor. The unit does not operate when cigarette smoke is in the air. The CLEAN FILTER Indicator Light remains activated even after replacing filter. The Plasmacluster Indicator Light or the CLEAN-SIGN Light will not activate. • Check to see if the filters are heavily soiled. • Clean or Replace the filters. • Plasmacluster Air Purifiers emit small traces of ozone which may produce an odor. These ozone emissions are well below safety levels . • Is the unit installed in a location that is difficult for the sensor to detect cigarette smoke? • Is the odor sensor opening blocked or clogged? (In this case, clean the openings.) (Refer to E-15) • After replacing filters, connect the power cord to an outlet and press the Filter Reset Button on the remote control. (Refer to E-16) • Check to see if the Display OFF Mode on the Remote Control is selected. If so, press the Display ON/OFF Button on the Remote Control to activate the indicator light. (Refer to E-14) ERROR DISPLAY LAMP INDICATION The "Silent" Fan Speed Indicator Light blinks. REMEDY Fan motor disconnected or abnormal. Operation stops. • Pressing the ON/OFF button will reset the error display, but if error occurs again, contact the Sharp Service Center. E-18