Sharp HT-SB500 HT-SB500 Operation Manual - Page 11

Speaker preparation (continued) To mount the speaker on the wall Caution: Be very careful to prevent the speaker [4.84 lbs. (2.2 kg)] from falling when mounting on the wall. Before mounting, check the wall strength. (Do not put on the veneer plaster or whitewashed wall. The speaker may fall.) If unsure, consult a qualified service technician. Mounting screws are not supplied. Use appropriate ones. Check all wall mount angle screws for looseness. Select a good location. If not, accidents may occur or the speaker may get damaged. SHARP is not responsible for accidents resulting from improper installation. Driving screws SHARP designed the speakers so you may hang them on the wall. Use proper screws (not supplied). See below for size and type. 1/8" (3.2 mm) 3/16" (5 mm) 3/8" (9 mm) Min. 7/8" (22 mm) Wall mount angle fixed to the wall (Horizontal position) 1 Fix the pattern paper to the wall in horizontal position as below. 1-3/4" (44 mm) 20-1/32" (509 mm) 1-3/4" (44 mm) 1-1/8" (29 mm) Wall surface HT-SB500 1-1/8" (29 mm) Pattern paper 2 Make a hole on the wall following the screw point marks on the pattern paper by using a drill. 1-1/4" (32 mm) Preparation for Use 3/8" (8-9 mm) Wall surface 3 Fix a wall mount plug into the hole using a hammer, until it is flush with the wall surface. 1-1/4" (32 mm) 3/8" (8-9 mm) Wall surface (Continued to the next page) 11