Sharp HT-SB500 HT-SB500 Operation Manual - Page 21

General control (continued) Subwoofer level control The speaker level can be adjusted. To increase the level, press the SUBWOOFER LEVEL button. To decrease the level, press the SUBWOOFER LEVEL button. -5 -4 ... +4 +5 Note: When sound from the speaker is distorted, decrease the subwoofer level. Center speaker level control The center speaker level can be adjusted. To increase the level, press the CENTER SPK LEVEL button. To decrease the level, press the CENTER SPK LEVEL button. Bass control -5 -4 ... +4 +5 1. Press the BASS/TREBLE button to select "BASS". 2. Within 5 seconds, press the VOLUME (+ or -) button to adjust the bass. Treble control -5 +5 1. Press the BASS/TREBLE button to select "TREBLE". 2. Within 5 seconds, press the VOLUME (+ or -) button to adjust the treble. -5 +5 Touch Sensing off mode During Stand-by mode, press the DIMMER/SENS ON/OFF button on the remote control and the STAND-BY indicator will turn from ORANGE to RED. To turn the power on, press the ON/STAND-BY button on the remote control or touch the ON/STAND-BY pad on the display panel. Function On the speaker: When the FUNCTION pad on speaker is touched, the input source will change. Touch the FUNCTION pad on speaker repeatedly to select desired input source. On remote control: Press the LINE 1-2 button repeatedly to select "L1" (LINE IN 1 input) or "L2" (LINE IN 2 input). Press the DIGITAL 1-2 button repeatedly to select "D1" (DIGITAL IN 1 input) or "D2" (DIGITAL IN 2 input). LINE 1 LINE 2 DIGITAL 1 DIGITAL 2 HT-SB500 Basic Operation Note: The backup function will protect the memorized function mode for a few hours should there be a power failure or the AC power cord becomes disconnected. Auto power on function: When you press the LINE 1-2 or DIGITAL 1-2 button on the remote control, the speaker will turn on at last function. Auto power off and auto detect signal: If no analogue signal is detected within 1 minute or if "D1"/ "D2" display is blinking and after 30 seconds during power on, the speaker will automatically go to stand-by mode. The STANDBY indicator turns orange. The speaker will automatically power ON if it detects audio signal from connected equipment. Note: Make sure to turn off any source/signal input to speaker before going to stand-by mode because it will cause the speaker to power ON again. 21