Sharp PG M20X PG-M20X Operation Manual - Page 33
Press, on the, remote control to select the, INPUT Mode., on the remote
UPC - 074000358355
View all Sharp PG M20X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
3 Press , or on the remote control to select the INPUT Mode. • Pressing on the projector switches the inputs in the following order: ¡ INPUT 1 ¡ INPUT 2 ¡ INPUT 3 Note • When no signal is received, "NO SIGNAL" will be displayed. When a signal that the projector is not preset to receive is received, "NOT REG." will be displayed. About the INPUT Modes INPUT 1 Used for projecting im(RGB/ ages from equipment that Component) sends RGB signals or Component signals connected to the DVI-DIGITAL/ANALOG input port. INPUT 2 (S-Video) Used for projecting images from equipment connected to the SVIDEO input terminal. INPUT 3 (Video) Used for projecting images from equipment connected to the VIDEO input terminal. 4 Press or on the remote control to adjust the volume of the speaker. Note • Pressing Pressing will raise the volume. will lower the volume. • On the projector, the volume can be adjusted by pressing or . • , on the projector operate as cursor buttons ( , ) when selecting setup or adjustment functions while adjusting menus or the lens. "On-screen Display (Example) INPUT 1 Mode Using DVI digital Using Analog RGB Using Component INPUT 2 Mode Using S-Video INPUT 3 Mode Using Video VOLUME buttons -29 ➝ ➝ ➝ Basic Operation