Sharp PN-E603 PN-E603 PN-E703 Operation Manual - Page 47
Controlling with a PC, ■ Basic operation
View all Sharp PN-E603 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
5. Click on "LAN SETUP" under NETWORK. 6. Specify the "DHCP CLIENT", "IP ADDRESS",etc. Controlling the Monitor with a PC (LAN) Controlling with a PC TIPS • For security, set a USER NAME and PASSWORD. ■ Basic operation You use Internet Explorer on a PC on the LAN to control the monitor. 1. Launch Internet Explorer on the PC. 2. In the "Address" box, type "http://" followed by your monitor's IP address followed by "/", then press the Enter key. You can confirm the IP address with the DISPLAY function. When prompted to enter a user name and password, type the user name and password that you specified in the security settings (see page 49), and click [OK]. 3. You can check, control, and change the monitor's status and settings by clicking the menu items on the left side of the screen. DHCP CLIENT If your LAN has a DHCP server and you wish to obtain an address automatically, change this setting to "ON". To set the address manually, set this to "OFF". IP ADDRESS If the DHCP CLIENT is set to "OFF", specify an IP address. SUBNET MASK If the DHCP CLIENT is set to "OFF", specify the subnet mask. DEFAULT GATEWAY If the DHCP CLIENT is set to "OFF", specify the default gateway. If you are not using a default gateway, specify "0.0.0.0". 7. When the setting is changed, click [Apply]. 8. Check the message and click [OK]. 9. Exit Internet Explorer. 10. Restore the PC's IP address jotted in Step 6, "(2) Specifying the PC's IP address". 11. Connect the monitor and the PC to the LAN. Caution • Wait 10 seconds after clicking [OK] before proceeding. • When operating using the remote control unit or similar, click [Refresh]. TIPS • When the IP address is set manually, the IP addresses of the monitor connected to the RS-232C output terminal and the daisy chain of connected monitors that follows can be assigned automatically. (See page 25.) • If you see an [Apply] button next to a setting, click it after you change that setting. TIPS • See pages 48 to 52 for details on each setting. • If you click [Refresh] before the screen finishes updating the current display, the "Server Busy Error" will appear. Wait for a moment before operating your monitor again. • You cannot operate the monitor while it is warming up. • If "DHCP CLIENT" is set to "ON", press DISPLAY on the remote control unit two times and then check the monitor's IP address. 47 E