Sharp R-CD2200M R-CD1200M , R-CD1800 , R-CD-2200M Operation Manual - Page 15
Counter Check/Clear
View all Sharp R-CD2200M manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Procedure 0 1 Display NO. CHECK 2 Enter memory number. (After entering the memory number, the memory setting of each content is shown for 1.5 seconds at 0.3 second intervals until the STOP/ CLEAR pad is pressed.) NO. CHECK After about 1 sec. CHECK CHECK CHECK CHECK CHECK CHECK STOP CLEAR 3 Press the STOP/CLEAR pad to exit from the Custom Help Function. NOTES: 1. If is displayed at step 2 the memory has not CHECK been programmed. 2. Multiple memories can be checked until the STOP/ CLEAR pad is pressed to exit from the Custom Help Function. 3. The way to enter memory numbers depends on the programmed Memory Input Method. 4. When Express Defrost is set for 30 minutes in the memory, and are displayed repeatedly at step 2. 7. Counter Check/Clear Confirm counters are set to "0" before using oven for the first time. Counter Check Counter check can be used to check the total number of times the oven has been used, or the number of times each pre-programmed memory pad, manual cooking, or Express Defrost has been used. Total usage Press the CUSTOM HELP pad twice within 2 seconds, then enter 7. Total usage will be displayed. To check more than one counter Press each pad as indicated below, after the previous usage is displayed. Total each memory usage Input memory number. Total manual cooking usage Press the SELECT TIME pad. Total Express Defrost usage Press the EXPRESS DEFROST pad. * Suppose you want to know total usage and each memory usage. In this case the oven was used 8268 times and memory 1 in any Memory Input Method was used 513 times. Procedure Display CUSTOM HELP x 2 7 After about 1 sec. 1 Press the CUSTOM HELP pad twice within CHECK 2 seconds, then enter 7. Total usage will be displayed. 0 1 2 Enter memory number 1, to check the total memory usage of memory 1. NO. CHECK NO. CHECK After about 1 sec. CHECK NOTES: 1. To exit from Counter Check, press the STOP/CLEAR pad. 2. Each counter will count up to 9999, and then will automatically reset to 0 and begin counting again. 3. As shown in the above example, multiple counters can be checked before pressing the STOP/CLEAR pad to exit. 4. Only Dual Digit Input Method can be used when inputting memory numbers in Counter Check/Clear. EN-14