Sharp R-CD2200M R-CD1200M , R-CD1800 , R-CD-2200M Operation Manual - Page 6

MAINTENANCE MODE Should any of maintenance indicators appear in the display, follow the instruction: CC Mode CC1 CC2 CC4 CC3 Reason Action required Operation time of magnetrons exceeds 1,250 hours. Operation time of the control unit, relays, switches exceeds 200,000 times. Call for service to replace the parts promptly. Failure to replace parts that have exceeded recommended operation time may cause failure of the microwave oven. Operation time of exhaust motor exceeds Even though CC3 is displayed, your oven can still be 3,000 hours. operated for short periods of time. Call for service to replace parts promptly. NOTES: 1. The CC and " * " indicator will appear in the display when recommended parts life is exceeded. The CC and " * " indicator can be cleared by pressing the STOP/CLEAR pad. Call for service to replace the parts promptly. Failure to replace parts that have exceeded recommended operation time may cause failure of the microwave oven. 2. If one maintenance mode or more than one maintenance mode occurs at the same time, the display will show CC and the numbers of the modes separated by a period. For example, if CC1 occurs, the display will show CC and 1 reciprocally or if CC2 and CC4 occur at the same time, the display will show CC and 2.4. reciprocally. GROUNDING INSTRUCTIONS GROUNDING INSTRUCTIONS This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. This appliance is equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded in accordance with the National Electrical Code and local codes and ordinances. WARNING - Improper use of the grounding plug can result in a risk of electric shock. The electrical requirements are 120 Volt, 60 Hz, AC only, and 20 Amp or more (R-CD1200M); 230/208 Volt, 60 Hz, AC only, and 15 Amp or more (R-CD1800M); 230/208 Volt, 60 Hz, AC only, and 20 Amp or more (R-CD2200M) fused electrical supply. It is recommended that a separate circuit serving only this appliance be provided. When installing this appliance, observe all applicable codes and ordinances. If it is necessary to use an extension cord, use only a 3-wire extension cord that has a 3-blade grounding plug and a 3-slot receptacle that will accept the plug on the appliance. The marked rating of the extension cord should be AC120 Volt 20 Amp (R-CD1200M), AC230/208 Volt 15 Amp (R-CD1800M), AC230/208 Volt 20 Amp (R-CD2200M). Consult a qualified electrician or serviceman if the grounding instructions are not completely understood or if doubt exists as to whether the appliance is properly grounded. Plug Configuration Receptacle Box Cover 3-Pronged plug (NEMA 5-20P) 3-Pronged Receptacle (NEMA 5-20R) Receptacle Box Cover 3-Pronged plug (NEMA 6-15P) 3-Pronged Receptacle (NEMA 6-15R) 120V 20A R-CD1200M 230V/208V 15A R-CD1800M Receptacle Box Cover 3-Pronged plug (NEMA 6-20P) 3-Pronged Receptacle (NEMA 6-20R) 230V/208V 20A R-CD2200M Radio or TV Interference Should there be any interference caused by the microwave oven to your radio or TV, check that the microwave oven is on a different electrical circuit, relocate the radio or TV as far away from the oven as feasible or check position and signal of receiving antenna. EN-5