Sharp UP-820N UP-820N Operation Manual - Page 117

11 Non-accessed UPC, Dynamic UPC and Customer Code X1/Z1 MODE Deletion X2/Z2 MODE You can delete UPCs and customer codes that have not been accessed for a certain period. You can program this period in the PGM2 mode. As for customer codes, you can delete any customer code with regardless of the non-accessed period. Follow the procedure below. Non-accessed UPC deletion 1. Enter the X1/Z1 mode from the mode selection window. 2. Select "2 RESETTING ". 3. Select "8 NON ACCESSED UPC" to delete non-accessed UPCs. 4. When you select"8 NON ACCESSED UPC", select whether to delete all the non-accessed UPCs at a time (1 ALL DELETE) or delete the non-accessed UPCs individually (2 IND.DELETE). NOTE It is recommended that you first take a report before deleting operation. Dynamic UPC clear 1. Enter the X1/Z1 mode from the mode selection window. 2. Select "2 RESETTING". 3. Select "9 D-UPC CLEAR" to clear a designated range of UPCs, "10 D-UPC CLEAR PICK" to pick up codes one by one to clear them (see the "NOTE" on page 89), or "11 D-UPC CLEAR DEPT" to clear codes on an associated department basis. Non-accessed customer deletion 1. Enter the X2/Z2 mode from the mode selection window. 2. Select "5 NON ACCESS. CUST.". 3. Select "1 READING" to take a report, or "2 DELETE" to delete non-accessed customer codes. 4. When you select "2 DELETE", select whether to delete all the non-accessed customer codes at a time (1 ALL DELETE) or delete non-accessed customers codes individually (2 IND.DELETE). NOTE It is recommended that you first take a report before deleting operation. Customer code deletion 1. Enter X2/Z2 mode from the mode selection window. 2. Select "6 CUSTOMER DELET. E" 3. Specify the range (start/end customer codes) you want to delete. - 115 -