Sharp VR-1FPN VR1FPN Operation Manual - Page 10
Inserting, removing, Batteries, FlashPath
View all Sharp VR-1FPN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Preparation Inserting (removing) the Batteries in the FlashPath 1 Set the FlashPath on a flat surface. 2 Hold down the battery cover and turn it counterclockwise to remove it. O Marks on battery cover 3 Insert (remove) the battery. Set the battery with the e side facing upwards and check that the side of the battery is touching the electrode in the cover. Check carefully that the electrode is not underneath the battery. Battery cover s CR2016 . - ElectrodAte:Z.4- -- 4 Set the battery cover over the battery, then hold down and turn it clockwise to fasten it in place. a O '_Marks on battery cover REPLACE BATTERY WITH TOSHIBA OR HITACHI MAXELL TYPE CR2016 ONLY. USE OF A DIFFERENT BATTERY MAY PRESENT A RISK OF FIRE OR EXPLOSION. WARNING KEEP THIS BATTERY AWAY FROM CHILDREN. IF SWALLOWED, CONSULT A PHYSICIAN IMMEDIATELY FOR EMERGENCY TREATMENT. CAUTION BATTERY MAY EXPLODE IF MISUSED OR INSTALLED WITH POLARITY REVERSED. DO NOT RECHARGE, DISASSEMBLE OR DISPOSE OF IN FIRE. Cautions: • The lithium battery will not function if installed with the polarity reversed. • Do not short-circuit, recharge, disassemble, or heat the battery. • Should the battery leak, wipe the battery compartment clean, and then insert a new battery. 7