Sharp XL-HF200P XL-HF200P Operation Manual - Page 6

Remote control ■ Battery installation ■ Volume control Turn the volume knob toward VOL +/- (on main unit) or press VOLUME +/- (on remote control) to increase or decrease the volume. Use 2 "AAA" size batteries (UM/SUM-4, R3, HP-16 or similar). Batteries are not included. Plastic film covering can be removed or peeled off. 1 Open the battery cover. 2 Insert the batteries according to the direction indicated in the battery compartment. When inserting or removing the batteries, push them toward the battery terminals. 3 Close the battery cover. Caution: ● Replace all old batteries with new ones at the same time. Do not mix old and new batteries. ● Do not mix old and new batteries. ● Remove the batteries if the unit will not be used for a long period of time. This will prevent potential damage due to battery leakage. ● Do not use rechargeable batteries (nickel-cadmium battery, etc.). ● Installing the batteries incorrectly may cause the unit to malfunction. ● Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like. Notes concerning use: ● Replace the batteries if the operating distance is reduced or if the operation becomes erratic. Purchase 2 "AAA" size batteries (UM/SUM-4, R3, HP-16 or similar). ● Periodically clean the transmitter on the remote control and the sensor on the unit with a soft cloth. ● Exposing the sensor on the unit to strong light may interfere with operation. Change the lighting or the direction of the unit. ● Keep the remote control away from moisture, heat, shock, and vibrations. General control ■ To turn the power on The first time the unit is plugged in, the unit will enter the demonstration mode. ■ Auto power on function When you press any of the following buttons, the unit turns on. ● iPod® / iPhone, CD, USB, AUDIO / LINE (INPUT), TUNER (BAND) on the remote control: Selected function is activated. ● button on the main unit: The unit turns on and playback of the last function will start (CD, TUNER, USB, iPod, AUDIO IN, LINE IN) ■ Auto power off function The main unit will enter the stand-by mode (when iPod/iPhone is not docked) after 15 minutes of inactivity during: iPod/iPhone: No connection. AUDIO IN / LINE IN: No detection of input signal or very low sound audibility. TUNER: No reception of broadcast signal. CD / USB: In the stop mode. Note: However, if iPod/iPhone is docked, the unit will begin charging. "Charge Mode" will be displayed. ■ Muting The volume is muted temporarily when pressing the MUTE button on the remote control. Press again to restore the volume. ■ X-Bass control When the power is first turned on, the unit will enter the extra bass mode which emphasizes the bass frequencies, and "X-BASS" will appear. To cancel the extra bass mode, press the X-BASS button on the remote control. ■ Bass control 1 Press the BASS/TREBLE button to select "BASS". 2 Within 5 seconds, press the VOLUME (+ or -) button to adjust the bass. ■ Treble control 1 Press the BASS/TREBLE button to select "TREBLE". 2 Within 5 seconds, press the VOLUME (+ or -) button to adjust the treble. Function Main unit Remote control Operation ■ Equalizer Power on/ off Demo on/ off ____ Press to turn the power on or to go to stand-by mode. Press to enter to demonstration on or off mode. ■ Display brightness control To dim the display brightness, press the DEMO/DIMMER button on the remote control. Dimmer 1 (Display is dim). Dimmer 2 (Display gets dimmer). Dimmer off (Display is bright). ■ Volume illuminator When the EQUALIZER MODE button is pressed, the current mode setting will be displayed. To change to a different mode, press the EQUALIZER MODE button repeatedly until the desired sound mode appears. Flat Equalizer off. Game For game. Classic For classical music. Pops For pop music. Vocal Vocals are enhanced. Jazz For jazz. ■ Function When the FUNCTION button on main unit is pressed, the current function will change to different mode. Press the FUNCTION button repeatedly to select desired function. CD FM STEREO FM MONO AM ● When the power is turned on, volume illuminator lights up. ● To turn on/off the light, hold down the DEMO/DIMMER button on the remote control for more than 2 seconds. ■ Volume auto fade-in Line In Audio In iPod USB Note: The backup function will protect the memorized function mode for a few hours should there be a power failure or the AC power cord becomes disconnected. If you turn off and on the main unit with the volume set to 27 or higher, the volume starts at 16 and fades in to the last set level. E-5