Sharp XL-HP707 XL-HP707 Operation Manual - Page 32

Troubleshooting chart

Page 32 highlights

XL-HP707 Troubleshooting chart ! Subwoofer connection When a commercially available speaker with a built-in amplifier is connected to this unit, you can enjoy sound with emphasized bass. Connect an RCA cord from a commercially available speaker with a built-in amplifier to the SUBWOOFER PRE-OUT jack. Many potential problems can be resolved by the owner without calling a service technician. If something is wrong with this product, check the following before calling your authorized SHARP dealer or service center. ! General Symptom Possible cause " The clock is not set to the " Did a power failure occur? Reset correct time. the clock. (Refer to page 15.) " When a button is pressed, " Set the unit to the power standthe unit does not respond. by mode and then turn it back on. " If the unit still malfunctions, reset it. (Refer to page 33.) " No sound is heard. " Is the volume level set to "0"? " Are the headphones connected? " Are the speaker wires discon- nected? Advanced Features Speaker with a built-in amplifier ! CD player Symptom Possible cause " Playback does not start. " Is the disc loaded upside down? " Playback stops in the mid- " Does the disc satisfy the stan- dle or is not performed dards? properly. " Is the disc distorted or scratched? " Playback sounds are " Is the unit located near excessive skipped, or stopped in the vibrations? middle of a track. " Is the disc very dirty? " Has condensation formed inside the unit? 32

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36

32
XL-HP707
Advanced Features
!
Subwoofer connection
When a commercially available speaker with a built-in amplifier is
connected to this unit, you can enjoy sound with emphasized bass.
Connect an RCA cord from a commercially available speaker with a
built-in amplifier to the SUBWOOFER PRE-OUT jack.
Troubleshooting chart
Many potential problems can be resolved by the owner without call-
ing a service technician.
If something is wrong with this product, check the following before
calling your authorized SHARP dealer or service center.
!
General
!
CD player
Speaker with a
built-in amplifier
Symptom
Possible cause
"
The clock is not set to the
correct time.
"
Did a power failure occur? Reset
the clock. (Refer to page 15.)
"
When a button is pressed,
the unit does not respond.
"
Set the unit to the power stand-
by mode and then turn it back on.
"
If the unit still malfunctions, reset
it. (Refer to page 33.)
"
No sound is heard.
"
Is the volume level set to "0"?
"
Are the headphones connected?
"
Are the speaker wires discon-
nected?
Symptom
Possible cause
"
Playback does not start.
"
Is the disc loaded upside down?
"
Playback stops in the mid-
dle or is not performed
properly.
"
Does the disc satisfy the stan-
dards?
"
Is the disc distorted or
scratched?
"
Playback sounds are
skipped, or stopped in the
middle of a track.
"
Is the unit located near excessive
vibrations?
"
Is the disc very dirty?
"
Has condensation formed inside
the unit?