Sharp XV-Z10000 Operation Manual - Page 22
Connecting the Projector to a Computer
View all Sharp XV-Z10000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Connections and Setup Connecting the Projector to Other Devices Connecting the Projector to a Computer Connecting to a Computer Using the the DVI to 15-pin D-sub Adaptor and the RGB Cable Connect the projector to the computer using the DVI to 15-pin D-sub adaptor and the RGB cable. • Secure the connectors by tightening the thumbscrews. Optional accessory DVI to 15-pin D-sub adaptor Type: AN-A1DV (7.9" (20cm)) DVI to 15-pin D-sub adaptor (sold separately) To RGB output terminal Notebook computer Note • See page 84 "Computer Compatibility Chart" for a list of computer signals com- patible with the projector. Use with com- puter signals other than those listed may cause some of the functions not to work. • When connecting the projector to a com- puter in this way, select "RGB" for "Signal Type" in the "Options" menu, or select the RGB mode by pressing on the re- mote control. See page 64. • A Macintosh adaptor may be required for use with some Macintosh computers. Con- tact your nearest Authorized SharpVision Service Center or Dealer. • Depending on the computer you are us- ing, an image may not be projected un- less the signal output setting of the com- puter is switched to the external output. Refer to the computer operation manual for switching the computer signal output settings. RGB Cable (commercially available) XV-Z10000#Print#p21_22.p65 21 02.10.25, 7:27 PM -21