Singer 1 One Instruction Manual 14 - Page 11
Reposici6n
View all Singer 1 One manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Removing Presser Foot with Shank • Raise needle to highest position by turning the hand wheel toward you. • Raise presser foot. • Loosen presser foot screw a and remove the shank, guiding it to the right. Replacing Presser Foot with Shank • Hook shank around the presser bar and tighten presser foot screw. Note: Insert the edge of a coin in the slot of the presser foot screw to loosen it and to tighten it securely. Attaching the Darning and Embroidery Foot • Remove presser foot with shank. • Guide darning and embroidery foot into position from back of machine. Make sure lifting finger b is above needleclamp c. • Tighten presser foot screw with coin. • To remove, loosen screw and guide foot away from you and to the right. Pour retirer le pied presseur avec la tige • Amenez l'aiguille en position haute en tournant, a la main, le volant vers vous. • Soulevez le pied presseur. • Devissez la vis a du pied presseur et retirez la tige en la dirigeant vers la droite. Pour remettre le pied presseur avec la tige • Accrochez la tige sur la barre du pres- seur et resserrez la vis du pied presseur. Note: Inserez une piece de monnaie dans la fettle de •la vis du pied presseur pour la desserrer et la resserrerfermentent. Pour fixer le pied a repriser • Retirez le pied presseur avec la tige. • Amenez le pied a repriser en position par I'arriere de la machine. Assurezvous que le doigt releveur b est au dessus du prince aiguille c. • Resserrez la vis du pied presseur avec une piece de monnaie. • Pour retirer: desserez la vis et guidez le pied en l'eloignant de vous par la droite. Remodel') del prensatelas con vastago • Levante la aguja hasta su position mas alts girando el volante hacia Usted. • Levante el prensatelas. • Afloje el tornillo del prensatelas a y saque el vastago, guiandolo hacia el lado derecho. Reposici6n del prensatelas con vastago • Enganche el vastago alrededor de la barra y apriete el tornillo del prensatelas. Nota: Inserte el canto de una moneda en la ranura del tornillo delprensatelaspara aflojarlo o apretarlo con firmeza. Instalacion del prensatelas para zurcir y bordar • Remueva el prensatelas con vastago. • Guie el prensatelas para zurcir y bordar en su posici6n desde la parte trasera de la maquina. Asegurese de que la una levantadora b se sitila encima del sujetador de aguja c. • Apriete el tornillo del prensatelas con el canto de una moneda. • Para remover, suelte el tornillo y guie el prensatelas hacia el lado derecho, alejandolo de Usted. 10