Sony AVD-K600P HTV600DP Operating Instructions (main amp/tuner for HTV) - Page 11
Connections, Connecting Antenna/Cable TV to, DVD/VCR Receiver
![]() |
View all Sony AVD-K600P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
PREPARATION Connections Tips Depending on your TV and other equipment you wish to connect, there are various ways you could connect the DVD/VCR Receiver. Use connections described on pages 11-14. Please refer to the manuals of your TV, VCR, Stereo System or other devices as necessary to make the best connections. Caution Make sure the DVD/VCR Receiver is connected directly to the TV. Tune the TV to the correct video input channel. Do not connect the DVD/VCR Receiver's AUDIO OUT jack to the phono in jack (record deck) of your audio system. Do not connect your DVD/VCR Receiver via your VCR. The DVD image could be distorted by the copy protection system. Connecting Antenna/Cable TV to DVD/VCR Receiver 1 Disconnect the antenna leads from the rear of the TV. 2 Identify the type of cable from your antenna. If it is a round cable as illustrated, it is a 75 ohm coaxial antenna cable. This cable will connect directly to the jack marked ANTENNA IN on your DVD/VCR Receiver. Tip If your antenna lead wire is a flat type antenna cable, connect it to an Antenna Adaptor (300-ohm to 75-ohm) (not supplied) and slip the Adaptor onto the ANTENNA IN jack. The Adaptor does not screw on to the DVD/VCR Receiver, it just slips over the jack. Without Cable Box If your cable wire is connected to your TV without a converter or descrambler box, unscrew the wire from your TV and attach it to the ANTENNA IN jack on the DVD/VCR Receiver. Use the supplied round coaxial cable to connect between the DVD/VCR Receiver's ANTENNA OUT jack and the 75 ohm antenna input jack on the TV. With this connection, you can receive all midband, super band, and hyperband channels. With Cable Box If a converter is required in your cable system, follow the instruction below: The cable hookup permits both TV and DVD/VCR Receiver operation. To view or record a CATV channel 1 Tune the TV to the DVD/VCR Receiver output channel (CH 3 or 4). 2 Set the DVD/VCR Receiver channel selector to the output channel of the Cable Converter box using CH/PRESET (+/-) or number (0-9) of your DVD/VCR Receiver. (Example: CH3) 3 Select the channel to view at the Cable Converter Box. Notes With this connection, you can not record one program while viewing another. If you are using a cable box to tune channels, it is not necessary to do Auto Channel Programming, (Auto Channel Search) as indicated on page 18. Back Panel of Typical Cable Box Cable TV Wall Jack Antenna Flat Wire (300 ohm) 300/75 ohm OR Adaptor (Not supplied) Antenna OR Cable TV Wall Jack Rear of DVD/VCR Receiver Rear of DVD/VCR Receiver 11
![](/manual_guide/products/sony-avdk600p-htv600dp-operating-instructions-main-amptuner-htv-8cdda4d/11.png)