Sony CCD-TRV238E User Manual - Page 92

Warning indicators and messages

Get Sony CCD-TRV238E PDF manuals and user guides View all Sony CCD-TRV238E manuals
Add to My Manuals
Save this manual to your list of manuals

Page 92 highlights

Warning indicators and messages Self-diagnosis display/Warning indicators If indicators appear on the screen, check the following. See the page in parentheses for details. Indication Cause and/or Corrective Actions C:ss : ss/E:ss : ss (Selfdiagnosis display) Some symptoms can be fixed by yourself. If the problem persists even after you tried a couple of times, contact your Sony dealer or local authorized Sony service facility. C:04:ss cA battery pack that is not an "InfoLITHIUM" battery pack is being used. Use an "InfoLITHIUM" battery pack. (p. 96) C:21:ss cMoisture condensation has occurred. Remove the cassette and leave your camcorder for at least 1 hour, then re-insert the cassette. (p. 99) C:22:ss cClean the head using a cleaning cassette (optional). (p. 99) C:31:ss / C:32:ss cSymptoms that are not described above have occurred. Remove and insert the cassette, then operate your camcorder again. Do not perform this procedure if moisture starts to condense. (p. 99) cRemove the power source. Reconnect it again and operate your camcorder again. cChange the tape. cPress the RESET button and operate your camcorder again. E:61:ss / E:62:ss cContact your Sony dealer or local authorized Sony service facility. Inform them of the 5-digit code, which starts from "E." E (Battery level warning) • The battery pack is nearly used up. • Depending on the operating, environmental, or battery conditions, the E indicator may flash, even if there are approximately 5 to 10 minutes remaining. % (Moisture condensation warning)* cEject the cassette, set the POWER switch to (CHG) OFF, and leave it for about 1 hour with the cassette lid open. (p. 99) Q (Warning indicator pertaining to the tape) Slow flashing: • There is less than 5 minutes remaining on the tape. • No cassette is inserted.* • The write-protect tab on the cassette is set to lock. (p. 95)* Fast flashing: • The tape has run out.* 92 Troubleshooting

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
Troubleshooting
92
Warning indicators
and messages
Self-diagnosis display/Warning indicators
If indicators appear on the screen, check the following. See the page in parentheses for details.
Indication
Cause and/or Corrective Actions
C:
ss
:
ss
/E:
ss
:
ss
(Self-
diagnosis display)
Some symptoms can be fixed by yourself. If the problem persists even after
you tried a couple of times, contact your Sony dealer or local authorized
Sony service facility.
C:04:
ss
c
A battery pack that is not an “InfoLITHIUM” battery pack is being used.
Use an “InfoLITHIUM” battery pack. (p. 96)
C:21:
ss
c
Moisture condensation has occurred. Remove the cassette and leave your
camcorder for at least 1 hour, then re-insert the cassette. (p. 99)
C:22:
ss
c
Clean the head using a cleaning cassette (optional). (p. 99)
C:31:
ss
/ C:32:
ss
c
Symptoms that are not described above have occurred. Remove and
insert the cassette, then operate your camcorder again. Do not perform
this procedure if moisture starts to condense. (p. 99)
c
Remove the power source. Reconnect it again and operate your
camcorder again.
c
Change the tape.
c
Press the RESET button and operate your camcorder again.
E:61:
ss
/ E:62:
ss
c
Contact your Sony dealer or local authorized Sony service facility.
Inform them of the 5-digit code, which starts from “E.”
E
(Battery level warning)
•
The battery pack is nearly used up.
•
Depending on the operating, environmental, or battery conditions, the
E
indicator may flash, even if there are approximately 5 to 10 minutes
remaining.
%
(Moisture condensation warning)*
c
Eject the cassette, set the POWER switch to (CHG) OFF, and leave it for
about 1 hour with the cassette lid open. (p. 99)
Q
(Warning indicator pertaining to
the tape)
Slow flashing:
•
There is less than 5 minutes remaining on the tape.
•
No cassette is inserted.*
•
The write-protect tab on the cassette is set to lock. (p. 95)*
Fast flashing:
•
The tape has run out.*