Sony CDX-M800 Operating Instructions - Page 25
Error displays/Messages - tuner
View all Sony CDX-M800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Automatic tuning is not possible. • The local seek mode is set to "on." t Set the local seek mode to "off" (page 18). • The broadcast signal is too weak. t Perform manual tuning. The "ST" indication flashes. • Tune in the frequency accurately. • The broadcast signal is too weak. t Set to the monaural reception mode (page 18). A program broadcast in stereo is heard in monaural. • The unit is in monaural reception mode. t Cancel monaural reception mode (page 18). Interference occurs during FM reception. The wide mode is selected. t Set the IF mode to "IF Auto" (page 18). Error displays/Messages Error displays (For this unit and optional CD/MD changers) The following indications will flash for about 5 seconds, and an alarm sound will be heard. Blank*1 No tracks have been recorded on an MD*2. t Play an MD with recorded tracks on it. Error*1 • A CD is dirty or inserted upside down*2. t Clean or insert the CD correctly. • A CD/MD cannot play because of some problem*2. t Insert another CD/MD. Failure*3 The connection of speakers/amplifiers is incorrect. t See the installation guide manual of this model to check the connection. FAILURE*3 When the XM tuner is connected, storing an XM radio channel into a preset failed. t Be sure to receive the channel that you want to store, then try it again. High Temp The ambient temperature is more than 50°C (122°F). t Wait until the temperature goes down below 50°C (122°F). NO Disc*1 No disc is inserted in the CD/MD unit. t Insert discs in the CD/MD unit. NO Magazine The disc magazine is not inserted in the CD/ MD unit. t Insert the magazine in the CD/MD unit. NO Music*2 A CD which is not a music file is inserted in the MP3 playable CD unit. t Insert a music CD in the MP3 playable CD unit. Not Ready The lid of the MD unit is open or the MDs are not inserted properly. t Close the lid or insert the MDs properly. Offset There may be an internal malfunction. t Check the connection. If the error indication remains on in the display, consult your nearest Sony dealer. continue to next page t 25