Sony DAV-DZ290K User Manual - Page 97
USB device, HDMI SETUP] to [OFF], then set [CONTROL FOR HDMI] in [HDMI
View all Sony DAV-DZ290K manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
Additional Information Symptom Remedy The Control for HDMI function • When "HDMI" does not light up in the front panel display, check the HDMI does not work. connection (page 18). • Set [CONTROL FOR HDMI] in [HDMI SETUP] to [ON] (page 53). • Make sure that the connected component is compatible with the [CONTROL FOR HDMI] function. • Check that the AC power cord (mains lead) of the connected component is connected securely. • Check the connected component's setting for the Control for HDMI function. Refer to the operating instructions supplied with the component. • If you change the HDMI connection, connect and disconnect the AC power cord (mains lead), or have a power failure, set [CONTROL FOR HDMI] in [HDMI SETUP] to [OFF], then set [CONTROL FOR HDMI] in [HDMI SETUP] to [ON] (page 53). • For details, see "Using the Control for HDMI Function for "BRAVIA" Sync" (page 61). No sound is output from the • Set [AUDIO (HDMI)] in [HDMI SETUP] to [ON] (page 54). system and TV while using the • Make sure that the connected TV is compatible with the System Audio Control System Audio Control function. function. • For details, see "Using the Control for HDMI Function for "BRAVIA" Sync" (page 61). USB device Symptom Remedy "OVERLOAD," "REMOVE • A problem has been detected with the level of electrical current from the USB," then "PUSH POWER" (USB) port. Turn off the system and remove the USB device from the appear in the front panel display. (USB) port. Make sure there is no problem with the USB device. If this display pattern persists, contact your nearest Sony dealer. Are you using a supported USB device? • If you connect an unsupported USB device, the following problems may occur. See "Playable USB Devices" (supplement) for the supported device types. - The USB device is not recognized. - File or folder names are not displayed on this system. - Playback is not possible. - The sound skips. - There is noise. - A distorted sound is output. - Transferring stops before it is finished. There is no sound. • The USB device is not connected correctly. Turn off the system, then reconnect the USB device. The sound is distorted. • The bit rate used when encoding the audio files was low. Transfer audio files encoded with higher bit rates onto the USB device. There is noise or the sound skips. • Turn off the system, then reconnect the USB device. • Noise may have entered during the transferring process. Delete the file, and try transferring again. • Copy the files to your computer, format the USB device in FAT12, FAT16, or FAT32 format, and transfer the files to the USB device again.* * This system supports FAT12, FAT16, and FAT32, but some USB devices may not support all of these. For details, refer to the operating instructions of each USB device or contact the manufacturer. 97GB