Sony DCR-HC28 Operating Guide - Page 13

5 The CHG (charge) lamp turns off when the battery is fully charged. Disconnect the AC Adaptor from the DC IN jack. Disconnect the AC Adaptor from the DC IN jack holding both the camcorder and the DC plug. To use an outside power source You can operate your camcorder using the power from the wall outlet by making the same connections as you do when charging the battery pack. The battery pack will not lose its charge in this case. To remove the battery pack 1 Slide the POWER switch to OFF(CHG). Hold down the V BATT(battery) release lever with one hand. 2 Remove the battery in the direction of the arrow with the other hand. POWER switch 1 2 V BATT (battery) release lever When storing the battery pack Fully discharge the battery before storing it for an extended period (p. 66). Charging time Approximate time (min.) required when you fully charge a fully discharged battery pack. Battery pack Charging time NP-FP30 (supplied) 115 NP-FP50 125 NP-FP71 170 NP-FP90 220 NP-FH50 135 NP-FH70 170 NP-FH100 390 Recording time Approximate time (min.) available when you use a fully charged battery pack. Battery pack Continuous recording time Typical recording time* NP-FP30 (supplied) 95 45 110 55 NP-FP50 135 65 160 80 NP-FP71 330 165 395 195 NP-FP90 500 250 580 290 NP-FH50 155 75 180 90 NP-FH70 330 165 NP-FH100 395 195 760 380 890 445 • All times measured under the following conditions: Top: Recording with LCD screen. Bottom: Recording with viewfinder while the LCD panel closed. * Typical recording time shows the time when you repeat recording start/stop, turning the power on/off and zooming. Continued , 13 Getting Started