Sony HCD-BC150 Operating Instructions - Page 57

By pressing Number TV/VIDEO 0 1 2 3 4 5 6 7* 8* TV's input source No input source (Default) VIDEO1 VIDEO2 VIDEO3 VIDEO4 VIDEO5 VIDEO6 COMPONENT 1 INPUT COMPONENT 2 INPUT * Except for North American models. 2 Press and hold TV CH + while entering the code for transmit time (see table below) using the number buttons. The transmit time from the remote is selected. If you successfully set the transmit time code, the TV button flashes twice slowly. If the setting is unsuccessful, the TV button flashes five times quickly. By pressing Number TV CH + 1 2 3 4 5 6 7 8 Transmit time 0.5 (Default) 1 1.5 2 2.5 3 3.5 4 Operation Point the remote to the direction of TV and this system, then press SONY TV DIRECT once. While transmitting the code from the remote, the TV button flashes. Notes • This function is only for the SONY TV series, however, some TV products may also not work. • If this function does not work, change the transmit time. The transmit time varies depending on the TV. • If distance between the TV and this system is too far, this function may not work. Install the system near the TV. • Keep the remote pointed in the direction of the TV and this system while the TV button is flashing. Other Operations Using the Video or Other Unit You can use a VCR or other unit(s) connected to the VIDEO/SAT jacks. Refer to the operation manual supplied with the unit for further information on the operation. 1 2 3 4 5 6 7 8 9 10 0 FUNCTION Press FUNCTION repeatedly until "VIDEO" appears in the front panel display. Each time you press FUNCTION, the mode of the system changes in the following sequence. When "ATTENUATE" is set to "ATT OFF." TUNER FM t TUNER AM t VIDEO t DVD t TUNER FM t ... When "ATTENUATE" is set to "ATT ON." TUNER FM t TUNER AM t SAT t DVD t TUNER FM t ... For details on "ATTENUATE", see 58 page. continued 57GB