Sony HCD-D670AV Service Manual - Page 15
Cd Volt/div : 200 Mv
View all Sony HCD-D670AV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
CD SECTION Note : 1. CD Block is basically designed to operate without adjustment. Therefore, check each item in order given. 2. Use YEDS-18 disc (3-702-101-01) unless otherwise indicated. 3. Use an oscilloscope with more than 10MΩ impedance. 4. Clean the object lens by an applicatior with neutral detergent when the signal level is low than specified value with the following checks. 5. Adjust the focus bias adjustment when optical block is replaced. Focus Bias Adjustment BD board TP(RF) TP(VC) oscilloscope (DC range) Procedure : 1. Connect oscilloscope to test point TP (RF). (Ground terminal : VC) 2. Turned Power switch on. 3. Put disc (YEDS-18) in and playback. 4. Adjust RV101 so that the waveform is clear. (Clear RF signal waveform means that the shape "◊" can be clearly distinguished at the center of the waveform.) 5. After adjustment, check the RF signal level. • RF signal VOLT/DIV : 200 mV TIME/DIV : 500 nS level 1.3 ± 0.3 Vp-p S Curve Check BD board TP(FE) TP(VC) oscilloscope Procedure : 1. Connect oscilloscope to test point TP (FEO). 2. Connect between test point TP (FOK) and Ground by lead wire. 3. Turn Power switch on. 4. Put disc (YEDS-18) in and turned Power switch on again and actuate the focus search. (actuate the focus search when disc table is moving in and out.) 5. Check the oscilloscope waveform (S-curve) is symmetrical between A and B. And confirm peak to peak level within 2.4 ± 0.7 Vp-p. S-curve waveform Symmetry within 2.4 ± 0.7 Vp-p 6. After check, remove the lead wire connected in step 2. Note : • Try to measure several times to make sure than the ratio of A : B or B :A is more than 10 :7. • Take sweep time as long as possible and light up the brightness to obtain best waveform. RF Level Check BD board TP(RF) TP(VC) oscilloscope Procedure : 1. Connect oscilloscope to test point TP (RF) on BD board. 2. Turned Power switch on. 3. Put disc (YEDS-18) in and playback. 4. Confirm that osilloscope waveform is clear and check RF signal level is correct or not. Note : Clear RF signal waveform means that the shape "◊" can be clearly distinguished at the center of the waveform. RF signal waveform VOLT/DIV : 200mV TIME/DIV : 500nS level : 1.3 ± 0.3 Vp-p - 15 -