Sony HSCU300RF Operation Manual - Page 28

NETWORK SETTINGS menu Page name Page No. N01 Item Settings IP ADDRESS SUBNET MASK DEFAULT GATEWAY SET 0.0.0.0 to 255.255.255.255 0.0.0.0 to 255.255.255.255 0.0.0.0 to 255.255.255.255 ENTER to execute N02 AUTO NEGOTIATION ON, OFF CONNECTION SPEED 10M, 100M DUPLEX MODE HALF, FULL LINK CONDITION (DOWN), (UP) N03 SET CNS MODE ENTER to execute LEGACY, BRIDGE, MCS CCU NO N04 MASTER IP ADDRESS ALL RESET Default: 0 0.0.0.0 to 255.255.255.255 ENTER to execute Indication IP address setting Subnet mask display Default gateway display A "SET OK?" message is displayed. Press ENTER again to confirm the change. Auto negotiation on/off of connection speed and communication mode with connected device Connection speed selection 10M: 10BASE-TX 100M: 100BASE-TX Configurable only when AUTO NEGOTIATION is off. Communication method selection HALF: Half-duplex communication FULL: Full-duplex communication Configurable only when AUTO NEGOTIATION is off. Communication mode display (read only) (DOWN): Not connected correctly (UP): Connected successfully A "SET OK?" message is displayed. Press ENTER again to confirm the change. Network connection mode selection LEGACY: External controller connected using CCA-5 cable only BRIDGE: External controller connected using point-to-point LAN cable MCS: (MCS mode operation available only when the multi-camera control system support software is installed.) Multi-camera system configuration of multiple network-capable devices. Requires 1 MSU-1000/1500 Master Setup Unit in the system as master device When CNS MODE is LEGACY or BRIDGE: 1 to 96, A to Z When CNS MODE is MCS: 1 to 24 Displayed only when the multi-camera control system support software is installed. A "NET SETTINGS RESET OK?" message is displayed. Press ENTER again to reset NETWORK SETTINGS menu items to factory default values. 28 Setup Menu