Sony HSCU300RF Operation Manual - Page 8
Rear Panel, CABLE CONDITION indicators
View all Sony HSCU300RF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
d MENU control block DISP/MENU (display/menu) lever and indicator CANCEL/ENTER lever Control knob • DISP/MENU (display/menu) lever and indicator Selects the status display or setup menu display. In setup menu mode, the indicator turns on. • CANCEL/ENTER lever In setup menu mode, used to cancel and enter settings. • Control knob (rotary encoder) In status screen mode, used to change the displayed page. In setup menu mode, used to move the cursor on a page and to change menu settings. Pressing the control knob performs the same function as setting the CANCEL/ENTER lever to the ENTER position. e POWER switch Switches the power for the entire system on and off, including the CCU, camera, and the RCP-1000-series Remote Control Panel connected to the REMOTE connector on the rear panel. Pressing the "?" side turns the camera system on, and pressing the "a" side turns it off. f POWER indicator CAM: Turns on when power is supplied to the camera. MAIN: Turns on when the CCU power supply is turned on. It flashes when there is a problem with the fan. g NETWORK indicator Displays the network system connection status. On: Indicates that external control equipment (MSU-1000/1500 Master Setup Unit, RCP-1000-series Remote Control Panel, or other device) is connected. Flashing: Indicates a connection problem with the external control equipment (MSU-1000/1500 Master Setup Unit, RCP-1000-series Remote Control Panel, or other device). Off: Indicates that a LAN cable is not connected or that the network system connection parameters have not been set. See "Network diagnostics" on page 14 and "NETWORK SETTINGS menu" on page 28. h CABLE CONDITION indicators Indicates the communication status of the camera (CAM) and camera control unit (CCU). When the two lamps on the right (green) are lighted: Reception status is excellent. When the second lamp from the right (green) is lighted: Reception status is good. When the second lamp from the left (yellow) is lighted: Reception status is low. When the lamp on the left (red) is lighted: Reception status is at the lowest level. • On the HSCU300RF, determined by the receive level of the optical signal on the camera and CCU. • On the HSCU300R, determined by the receive level of the RF signal on the CCU. Rear Panel a b c d ef g h i j k Memory stick slot (for use by service personnel only) l m no p HSCU300RF diagram shown. a REFERENCE IN/OUT (reference input) connectors (BNC type) Inputs an HD tri-level reference sync signal or SD reference sync signal (black burst signal) on either of the two connectors. The input signal is output from the other connector as-is (loopthrough output). The signal is input on the upper connector. The lower connector is terminated automatically if no connector is connected. b PROMPTER 1, 2 (teleprompter input 1, 2) connectors (BNC type) Inputs the VBS signals for the teleprompter. Note On the HSCU300RF, only one system from the two systems on the PROMPTER1 and 2 connectors is enabled. c VBS RETURN 1, 2 (VBS return video 1, 2 input) connectors (BNC type) Inputs the 2-system VBS return video signals. 8 Locations and Functions of Parts