Sony HT-DDW795 Operating Instructions - Page 50

Using the Remote Changing button assignments You can change the factory settings of the input buttons to suit the components in your system. For example, if you connect a DVD player to the SAT jacks on the receiver, you can set the SAT button on this remote to control the DVD player. 1 Hold down the input button of which you want to change the assignment. Example: Hold down SAT. 2 Referring to the table below, press the corresponding button for the category you want. Example: Press 4. Now you can use the SAT button to control the DVD player. Categories and the corresponding buttons Categories Press VCR (command mode VTR 3)a) 1 VCR (command mode VTR 2)a) 2 DVD player/DVD recorder 3 (command mode DVD1)b) DVD recorder 4 (command mode DVD3)b) CD player 5 Euro Digital Satellite Receiver 6 DVR (Digital CATV terminal) 7 DSS (Digital Satellite Receiver) 8 Blu-ray disc player 9 (command mode BD1)c) Blu-ray disc recorder 0/10 (command mode BD3)c) TV -/-- Not assigned ENTER/ MEMORY a)Sony VCRs are operated with a VTR 2 or VTR 3 setting which corresponds to 8 mm and VHS respectively. b)Sony DVD recorders are operated with a DVD1 or DVD3 setting. For details, refer to the operating instructions supplied with the DVD recorders. c)For details on the BD1 or BD3 setting, refer to operating instructions supplied with the blu-ray disc player or blu-ray disc recorder. To clear all remote button assignments Press ?/1, AUTO CAL and MASTER VOL - at the same time. The remote is reset to its factory settings. 50US