Sony MHC-MG310AV Operating Instructions (primary manual) - Page 15

CD Programing CD tracks - Program Play You can make a program of up to 25 tracks from all the CDs in the order you want to play them. 1 Press CD to switch the function to CD. 2 Press PLAY MODE repeatedly until "PGM" appears. 3 Turn DISC ACCESS (or press TDISC or DISCt on the remote) to select a CD. To program all the tracks on a CD at once, go to step 5 with "CDAL" displayed. 4 Press - . or > + (or . or > on the remote) repeatedly until the desired track appears. Disc number Track number Playing time of selected track 5 Press ENTER. The track is programed. The programed track and corresponding step (playing order) appear. 6 Program additional discs or tracks. To program Repeat steps Other discs 3 and 5 Other tracks on the same disc 4 and 5 Other tracks on other discs 3 to 5 7 Press n N (or N on the remote). Other Operations To Do this Cancel Program Press PLAY MODE repeatedly play until "PGM" disappears. Check the program Press - . or > + (or . or > on the remote) repeatedly during Program Play. Clear a track or Press CLEAR in stop mode. disc from the end Clear the entire Press and hold CLEAR. program Add tracks or discs to the program in stop mode Perform steps 3 to 5. Tips • The program you made remains after Program Play finishes. To play the same program again, press CD, then press n N (or N on the remote) in Program Play mode. • "--.--" appears when the total CD program time exceeds 100 minutes, or when you select a CD track whose number is 21 or over. • The programed disc and track numbers remain until you erase them, so that the system plays only the existing disc and track numbers if you replace discs. However, the disc and track numbers that are not found in the system or on the disc are deleted from the program, and the rest of the program is played in the programed order. 15