Sony MKS-R1620 Operating Instructions - Page 27

(Source) (Destination) Configured area Unconfigured area When a destination outside the range limit is selected, sources 1 to 9999 are available for selection. In this example, sources 0001 to 9999 are available for selection for destination 3001. The sources in the range containing the selected destination are all enabled. In this example, sources 0001 to 3000 and 5001 to 8000 are available for selection for destination 0001. Adding a range 1 Click the [+] button. 2 Enter a source range and destination range in the dialog. 3 Click the [Apply] button. The specified settings are displayed in the list. Selecting a row in the list displays a blue rectangle covering the range available for selection. Alias Name Lists Page Displays alias names sent from the system controller. Select [Source] or [Destination] to display the list of alias names for sources or destinations, respectively. Default Controls Page Use to set the operation levels and default destination of the unit. Destination Settings Control Destination Set the destination that is selected when power is turned on. Level Settings Level Mode Select level selection mode. This item is enabled on the MKS-R1620/R1630 only. Single: Only one level can be selected. When a selection button is pressed, only that level is enabled, and other selected levels are de-selected. Multi: Multiple levels can be selected. The levels for a pressed selection button are all selected. When a selected button is pressed, the levels of that button are de-selected. Use Level Type Select the levels to use in the unit. System: Use the levels specified by the system controller. Local: Place a check mark in levels to set the levels used by [Control Level]. Operation Settings Page Use to configure settings relating to the operation of the remote control panel. Mode Settings Protect Mode Set the operation mode when protection is applied. The PROT lamp action is the same when either mode is selected. Protect: Crosspoint switching is disabled when protection is applied. Occupy: Crosspoint switching of protected remote control panels only is enabled when protection is applied. Salvo Protect This selects the process if salvo switching is executed while destinations are protected. Partial Protect: Switch only unprotected destinations. Full Protect: Do not perform salvo switching if any one of the destinations is protected. Select this mode if a problem would occur if any one location does not switch. Button Link: Do not perform salvo switching if the PROT lamp on the panel is lit. Note When [Protect Mode] is set to [Occupy] in the web menu to enable local protection, salvo switching is not restricted by the [Salvo Protect] setting. BPS/MD Take Mode (Enabled only on MKS-R1630) Select the Take operation for the BPS selection method and MD selection method. Immediate: Immediate Take mode In BPS mode, the Take function is executed at the moment the source selection button is pressed. In MD selection mode, the Take function is executed at the moment when the button with the assigned source is pressed. Preset: Preset Take mode After a source selection button (BPS selection mode) or button with assigned source (MD selection mode) is pressed, the Take function is executed at the moment when the Take button is pressed. • When a selection button is pressed, the content assigned to the button is displayed in [Source] and [Destination] in the status display window. 27