Home » Sony Manuals » Audio Players & Recorders » Sony MZ-R900 » Manual Viewer

Sony MZ-R900 Operating Instructions - Page 17

Record an MD

Add to My Manuals
Save this manual to your list of manuals

Page 17 highlights

2 Record an MD END SEARCH REC x 1 Press and slide REC to the right. " REC" lights up and recording starts. 2 Play the CD or tape you want to record. To stop recording, press x. After you press x, the recorder will automatically turn off in about 10 seconds (when using batteries) or about 5 minutes (when using AC power adaptor). To Record from the end of the previous recording1) Record partway through the previous recording1) Pause Remove the MD Press END SEARCH, and then press and slide REC to the right. Press jog lever (R) (N), or flip the jog lever (R) towards > or . to find the start point of recording and press x to stop. Then press and slide REC to the right. X2) Press X again to resume recording. x and open the lid.3) (The lid does not open while " TOC Edit" flashing in the display.) 1) By setting " REC-Posi" to " From End" , recording operations will always start from the end of the previously recorded material (page 25). 2) A track mark is added at the point where you press X again to resume recording while pausing; thus the remainder of the track will be counted as a new track. 3) If you open the lid while " REC-Posi" is set to " From Here" , recording will begin with the first track the next time you record. Check the point to start recording on the display. If the recording does not start • Make sure the recorder is not locked (page 55). • Make sure the MD is not record-protected (page 59). • Premastered MDs cannot be recorded over. For models supplied with the AC plug adaptor If the AC power adaptor does not fit the wall outlet, use the AC plug adaptor. Notes • " Data Save" or " TOC Edit" flashes while data of the recording (the track's start and end points, etc.) is being recorded. Do not move or jog the recorder or disconnect the power source while the indication is flashing in the display. • The lid does not open until " TOC Edit" disappears in the display. • If the power supply is disrupted (i.e. the battery is removed or becomes exhausted or the AC power adaptor is disconnected) during a recording or editing operation, or while " TOC Edit" appears in the display, then it will not be possible to open the lid until power is restored. 17-GB

Section	Page
Table of contents	4
Looking at controls	8
The recorder	8
The display window of the recorder	9
The headphones/earphones with a remote control	10
The display window of the remote control	10
Before using the recorder	11
Getting started!	13
Recording an MD right away!	16
Playing an MD right away!	19
Various ways of recording	21
Two ways of connecting to a sound source	21
Recording with analog input (line cable required)	22
Recording for long times	23
To start/stop recording in sync with the source player (Synchrorecording)	24
Recording without overwriting existing material	25
Recording from a microphone	25
Adding track marks automatically at specified intervals (Auto Time Stamp)	26
Adjusting the recording level manually (Manualrecording)	27
Checking the remaining time or the recording position	28
On the recorder	28
On the remote control	29
Setting the clock to stamp the recorded time	30
Copying CD text information while recording (Joint Text)	31
Various ways of playback	34
Selecting a track directly	34
Changing the playback order	34
On the recorder	34
On the remote control	35
To adjust the sound quality (Digital Sound Preset)	36
To change playback speed (Speed Control)	38
Storing the settings for individual discs (Personal Disc Memory)	38
On the recorder	39
On the remote control	39
Checking the remaining time or the playing position	40
On the recorder	40
On the remote control	41
Connecting to a stereo system (LINE OUT)	41
Editing recorded tracks	43
Erasing tracks	43
To erase a track	43
To erase the whole disc	43
Adding a track mark	44
Erasing a track mark	44
Moving recorded tracks	45
On the recorder	45
On the remote control	46
Labeling recordings	46
On the recorder	46
On the remote control	48
Storing phrases frequently used in labeling (Phrase Bank)	49
On the recorder	49
On the remote control	51
Other operation	53
Setting the alarm (Melody Timer)	53
On the recorder	53
On the remote control	53
Protecting your hearing (AVLS)	55
Locking the controls (HOLD)	55
Turning off the beep sound	56
Power sources	57
Battery life	57
Additional information	58
Precautions	58
Troubleshooting	61
System limitations	64
Messages	65
Specifications	68
What is an MD?	69
Índice	74
Controles	78
Grabadora	78
Visor de la grabadora	79
Auriculares/cascos con mando a distancia	80
Visor del mando a distancia	80
Antes de usar la grabadora	81
Procedimientos iniciales	83
Grabación de un MD	86
Reproducción de un MD	89
Opciones de grabación	91
Dos maneras de conectar con una fuente de sonido	91
Grabación con entrada analógica (requiere cable de línea)	92
Grabación de larga duración	93
Cómo iniciar y detener la grabación sincronizada con el reproductor fuente (grabación sincronizada)	94
Grabación sin sustituir el material existente	95
Grabación con un micrófono	95
Cómo añadir marcas de pista automáticamente a intervalos determinados (inserción automática)	96
Ajuste manual del nivel de grabación (grabaciónmanual)	97
Comprobación del tiempo restante o de la posición de grabación	98
En la grabadora	98
En el mando a distancia	99
Ajuste del reloj para incluir la hora de grabación	100
Copia de información de texto del CD durante la grabación (Joint Text)	101
Opciones de reproducción	104
Selección de una pista directamente	104
Cambio del orden dereproducción	104
En la grabadora	104
En el mando a distancia	105
Cómo ajustar la calidad del sonido (preajuste de sonido digital)	106
Cómo cambiar la velocidad de reproducción (control de velocidad)	108
Cómo guardar laconfiguración delosdiscos (memoria del disco personal)	108
En la grabadora	109
En el mando a distancia	109
Comprobación deltiempo restante ode la posición dereproducción	110
En la grabadora	110
En el mando a distancia	111
Conexión a un sistema estéreo (LINE OUT)	111
Edición de pistas grabadas	113
Borrado de pistas	113
Cómo borrar una pista	113
Cómo borrar todo el disco	113
Adición de una marca de pista	114
Borrado de una marca de pista	114
Cambio de orden depistas grabadas	115
En la grabadora	115
En el mando a distancia	116
Etiquetado de grabaciones	116
En la grabadora	116
En el mando a distancia	118
Almacenamiento defrases frecuentes enel etiquetado (banco de frases)	119
En la grabadora	119
En el mando a distancia	121
Otras operaciones	123
Ajuste de la alarma (temporizador de la melodía)	123
En la grabadora	123
En el mando a distancia	123
Protección auditiva (AVLS)	125
Bloqueo de los controles (HOLD)	125
Desactivación delpitido	126
Fuentes de alimentación	127
Duración de la pila	127
Información adicional	128
Precauciones	128
Solución de problemas	131
Limitaciones del sistema	134
Mensajes	135
Especificaciones	138
¿Qué es un MD?	139
Índice	144
Apresentação dos controlos	148
O gravador	148
A janela do visor do gravador	149
Os auscultadores/auriculares com um telecomando	150
A janela do visor do telecomando	150
Antes de utilizar o gravador	151
Como começar	153
Gravar um MD imediatamente!	156
Reproduzir um MD imediatamente!	159
Os vários métodos de gravação	161
Duas maneiras de se ligar a uma fonte de som	161
Gravação com entrada analógica (cabo de linha necessário)	162
Gravar durante períodos muito prolongados	163
Para iniciar/concluir uma gravação em sincronia com o leitor (Gravaçãosincronizada)	164
Gravação sem substituir o material existente	165
Gravar com um microfone	165
Adicionar marcas de faixas automaticamente em intervalos especificados (Registo automático de hora)	166
Regulação manual do nível de gravação (Gravaçãomanual)	167
Verificação do tempo restante ou da posição de gravação	168
No gravador	168
No telecomando	169
Acertar o relógio para que registe a hora degravação	170
Copiar as informações de texto do CD durante a gravação (Juntar texto)	171
Os vários modos de reprodução	174
Selecção directa de uma faixa	174
Alterar a ordem de reprodução	174
No gravador	174
No telecomando	175
Ajustar a qualidade de som (Programação desom digital)	176
Alterar a velocidade de reprodução (Controlo da velocidade)	178
Guardar as programações para discos individuais (Memória pessoal do disco)	178
No gravador	179
No telecomando	179
Verificação do tempo restante ou da posição de reprodução	180
No gravador	180
No telecomando	181
Ligação a um sistema estéreo (LINE OUT)	181
Montagem de faixas gravadas	183
Apagar faixas	183
Para apagar uma faixa	183
Para apagar todo o disco	183
Adicionar uma marca de faixa	184
Apagar uma marca defaixa	184
Mover faixas gravadas	185
No gravador	185
No telecomando	186
Identificar gravações	186
No gravador	186
No telecomando	188
Guardar as frases que utiliza frequentemente na identificação (Bancode frases)	189
No gravador	189
No telecomando	191
Outras operações	193
Programar o alarme (Melody Timer)	193
No gravador	193
No telecomando	193
Protecção dos ouvidos (AVLS)	195
Bloqueio dos controlos (HOLD)	195
Desligar o sinal sonoro	196
Fontes de alimentação	197
Duração das pilhas	197
Informações adicionais	198
Precauções	198
Resolução de problemas	201
Limitações do sistema	204
Mensagens	205
Especificações	208

Match case Limit results 1 per page

-GB

Record an MD

Press and slide REC to the right.

“ REC” lights up and recording starts.

Play the CD or tape you want to record.

To stop recording, press

After you press

, the recorder will

automatically turn off in about 10 seconds

(when using batteries) or about 5 minutes

(when using AC power adaptor).

If the recording does not start

•

Make sure the recorder is not locked

(page 55).

•

Make sure the MD is not record-protected

(page 59).

•

Premastered MDs cannot be recorded over.

For models supplied with the AC plug

adaptor

If the AC power adaptor does not fit the wall

outlet, use the AC plug adaptor.

Notes

•

“ Data Save” or “ TOC Edit” flashes while data

of the recording (the track’s start and end

points, etc.) is being recorded. Do not move or

jog the recorder or disconnect the power

source while the indication is flashing in the

display.

•

The lid does not open until “ TOC Edit”

disappears in the display.

•

If the power supply is disrupted (i.e. the

battery is removed or becomes exhausted or

the AC power adaptor is disconnected) during

a recording or editing operation, or while

“ TOC Edit” appears in the display, then it will

not be possible to open the lid until power is

restored.

END SEARCH

REC

Press

Record from the end of the previous

recording

END SEARCH, and then press and slide

REC to the right.

Record partway through the previous

recording

Press jog lever (R) (

), or flip the jog

lever (R) towards

to find the

start point of recording and press

to stop.

Then press and slide REC to the right.

Pause

Press

again to resume recording.

Remove the MD

and open the lid.

(The lid does not open

while “ TOC Edit” flashing in the display.)

By setting “ REC-Posi” to “ From End” , recording operations will always start from the end of the

previously recorded material (page 25).

A track mark is added at the point where you press

again to resume recording while pausing; thus

the remainder of the track will be counted as a new track.

If you open the lid while “ REC-Posi” is set to “ From Here” , recording will begin with the first track

the next time you record. Check the point to start recording on the display.