Sony PEG-S320 PictureGear Pocket v1.12 Operating Instructions - Page 29

PictureGear Pocket During Infrared communication Cannot find receiver's CLIE Handheld. Cause When [Beam Receive] in Preferences is turned off or the distance or the direction of the receiving CLIE handheld is too far IR Communication is impossible. The following message appears on the sender's CLIE handheld during Infrared communication'. 4~8 inches Receiving Side Sending Side Warning dialog Solution Turn [Beam Receive] on for the receiving handheld. Tap the "Preferences" icon of [Home] to open [Preferences]. In the drop-down menu, select "General" and turn [Beam Receive] on. Solution When [Beam Receive] is on, confirm that the IR port of the sender and the receiver are placed within rare to communicate each other. In other words, both the IR ports have to face each other at 4 ~ 8 inches (10 ~ 20 cm) without any obstacles. The optimal data transfer distance may differ depending on the operational relation between the CLIE handheld and your computer, or devices other than Sony. Change the distance and try the procedure again. The battery consumption is a little higher when "Beam receive" is left on. Cannot locate the receiver 's PictureGear application. Cause When the following warning dialog is displayed on the receiver's CLIE handheld, PictureGear Pocket is not installed on the receiver's CLIE handheld. Warning dialog Solution Install PictureGear Pocket on the receiver's CLIE handheld. Cannot HotSync. After connecting the line, you cannot perform HotSync operation with your computer. Cause You cannot perform HotSync operation when the line is still connected after using communication software such as Palmscape or CLIEMail. Solution Disconnect the line. To disconnect the line, change to "Network" in the upper-right drop-down menu of the "Preferences" screen, and then tap the "disconnect" button. 5.2