Sony PXW-FX9 Operating Instructions - Page 117
Wireless LAN Connection, Internet Connection, When using the ND Filter, Screwdriver hole
View all Sony PXW-FX9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 117 highlights
117 8. Appendix: Troubleshooting Wireless LAN Connection When using the ND Filter [Note] Obstructions and electromagnetic interference between the camcorder and wireless LAN access point or terminal device, or the ambient environment (such as wall materials) could shorten the communication range or prevent connections altogether. If you experience these problems, check the connection/communication status after moving the camcorder to a new location, or bringing the camcorder and access point/terminal device closer together. Symptom A terminal device cannot access the camcorder. Solution ˎˎ Check the wireless LAN connection (IP address, etc.). ˎˎ The communication setting between the access point and client may be invalid. For details, refer to the operating instructions of the access point. You cannot log in to the camcorder. Check the user name and password that you set. The web remote control does not appear. Check the IP address setting. Symptom The ND filter does not move. Solution You can move the filter to the Clear position manually using the following procedure. 1 Turn the camcorder POWER switch to the off position. 2 Remove the round cap on the bottom side. 3 Insert a screwdriver in the hole and turn it counterclockwise. ˎˎThe ND filter moves to the Clear position by turning counterclockwise. Continue turning until reaching the Clear position. ˎˎUse a screwdriver with ø2.4 mm diameter or smaller. The insertion depth of the screwdriver is about 3.0 cm (1 3/16 in.). Internet Connection Symptom File uploading fails. File uploading is not available. Solution The user name and password of the server may not be correct. Input the correct user name and password. 3G/4G signal conditions may be poor. Move to another location and try again. Screwdriver hole (with cap removed) 4 Set the ND PRESET/VARIABLE switch (page 6) to the PRESET position, and set the ND FILTER POSITION up/down buttons (page 6) to the CLEAR position. [Notes] ˎˎ Do not use the procedure above during normal operation. Only use this procedure if the ND filter will not move. The ND filter may become damaged if this procedure is used during normal operation. ˎˎ After the procedure above is used, consult a Sony service center to have the camcorder repaired. ˎˎ If an error message still appears after performing the procedure above, shooting is still possible.