Sony PXW-FX9 Operating Instructions - Page 119
Caution and Operation Messages, Appendix: Error/Warning Messages
View all Sony PXW-FX9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 119 highlights
119 8. Appendix: Error/Warning Messages Caution and Operation Messages The following caution and operation messages may appear in the center of the screen. Follow the instructions provided to resolve the issue. Display message Battery Error Please Change Battery Backup Battery End Please Change Unknown Media (A) 1) Please Change Cannot Use Media (A) 1) Unsupported File System Media Error Media (A) 1) Needs to be Restored Media Error Cannot Record to Media (A) 1) Media Error Cannot Use Media (A) 1) Media (A) 1) Error Recording Halted Playback Halted Media Reached Rewriting Limit Change Media (A) 1) Cause and Solution An error was detected in the battery pack. Replace with a normal battery pack. The remaining capacity of the backup battery is insufficient. Charge the backup battery. A memory card that has been partitioned or a memory card containing more clips that can be handled by the camcorder was inserted. The card cannot be used in the camcorder, and must be replaced. A card using a different file system or an unformatted card was inserted. The card cannot be used in the camcorder, and must be replaced or formatted using the camcorder. An error occurred on the memory card, and the card must be restored. Restore the memory card. The memory card may be damaged, and can no longer be used for recording. Playback is possible, so making a copy and replacing the memory card is recommended. The memory card may be damaged, and can no longer be used for recording or playback. The card cannot be used in the camcorder, and must be replaced. Recording and playback was stopped because an error occurred while using the memory card. If the problem persists, replace the memory card. The memory card has reached the end of its life. Make a backup, and replace the card immediately. If you continue using the card, the card may not be able to record or play. For details, refer to the operating instructions for the memory card. Display message Copy All Sub Clips NG: Reached Clip Number Limit NG: Same File Already Exists NG: Not Enough Capacity Cause and Solution Copying of all sub-clips using Copy All Sub Clips failed because of the displayed reason. ˎˎ The maximum number of clips is reached. ˎˎ There is a file with the same name. ˎˎ There is not enough capacity for copying. Replace the media. The specified address is invalid. The specified address is invalid. Check that the setting is correct. Cannot Use Specified Port Number The specified port number is invalid. Check that the setting is correct. Fan Stopped The built-in fan stopped. Avoid use at high temperatures, disconnect the power, and contact your Sony service representative. Invalid setting value was reset: Media/Clip Naming/Camera Position Please save All File again The Clip Naming format setting was reset because an invalid ALL file was loaded. Configure the desired format settings, and try to save the ALL file again. Lens I/F Error(xx:xx) A lens error was detected in the lens I/F communication when an E-mount lens was attached. Check the status of the connection with the E-mount lens. If the problem persists, contact your Sony service representative with the error code (five characters in parentheses). This Multi Term. acc is not supported An incompatible accessory was detected. by the device and cannot be used. The only Multi Terminal accessory supported by the unit is the Please verify the compatibility. supplied grip remote control. Failed This error may appear if an address cannot be obtained with DHCP set to On. Check the DHCP server settings. Cannot add auto upload job of Proxy file because maximum number of upload jobs was reached. The maximum number of transfer jobs has been reached. Clear any unwanted jobs. The auto upload destination setting for proxy files may also be incorrect. Check that the setting is correct. Not found. Network (access point) with the specified could not be found. Check that the setting is correct. Authentication Failed Connection authentication on the network (access point) with the specified failed. Check that the password and other settings are correct.