Sony SDM-HS75 Operating Instructions - Page 7

Setup Before using your monitor, check that the following items are included in your carton: • LCD display • Power cord • HD15-HD15 video signal cable (analog RGB) • Cord strap • CD-ROM (utility software for Windows/Macintosh, Operating Instructions, etc.) • Warranty card • Quick Setup Guide Step 1: Open the stand Connect a computer equipped with an HD15 output connector (analog RGB) Using the supplied HD15-HD15 video signal cable (analog RGB), connect the computer to the monitor's HD15 input connector (analog RGB). Connect the computer according to the following illustrations. x Connecting to an IBM PC/AT or compatible computer to the HD15 input connector (analog RGB) Note The stand is folded at the factory. Be sure not to place the display vertically with the stand as it is. Otherwise, the display may topple over. Step 2: Connect the display to your computer Turn off the monitor and computer before connecting. Notes • Do not touch the pins of the video signal cable connector as this might bend the pins. • Check the alignment of the HD15 connector to prevent bending the pins of the video signal cable connector. to the computer's HD15 output connector (analog RGB) IBM PC/AT or compatible computer HD15-HD15 video signal cable (analog RGB) (supplied) GB x Connecting to a Macintosh computer When connecting this monitor to a Macintosh computer, use the Macintosh adapter (not supplied) if necessary. Connect the Macintosh adapter to the computer before connecting the cable. to the HD15 input connector (analog RGB) to the computer's output connector Macintosh computer HD15-HD15 video signal cable (analog RGB) (supplied) 7