Sony SDM-N50PS Operating Instructions (primary manual) - Page 8
Setup - accessories
View all Sony SDM-N50PS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Setup Before using your monitor, check that the following accessories are included in your carton: • LCD display • Media engine • Display stand • Media engine stand • Power cord • System connecting cable (2 m) (applicable cable type: DP-2) • HD15 (RGB) video signal cable • Audio cord (stereo miniplug) • Macintosh adapter • Windows Monitor Information Disk/Utility Disk • Macintosh Utility Disk • Software for use when installing the display vertically (WinPortrait/MacPortrait) • Warranty card • Notes for Macintosh users • This instruction manual Step 1: Connect the media engine to your computer Turn off the media engine and computer before connecting. Note Do not touch the pins of the video signal cable connector as this might bend the pins. x Connecting to an IBM PC/AT or compatible computer x Connecting to a Macintosh or compatible computer Use the supplied Macintosh adapter. to INPUT1 or INPUT2 connector Macintosh adapter (supplied)* to video output HD15 (RGB) video signal cable (supplied) Macintosh or compatible computer * Refer to the supplied "Notes for Macintosh users" for further details. Step 2: Connect the display and media engine Turn off the display and media engine before connecting. to INPUT1 or INPUT2 connector to video output IBM PC/AT or compatible computer HD15 (RGB) video signal cable (supplied) to SYSTEM CONNECTOR of the display to SYSTEM CONNECTOR of the media engine system connecting cable (2 m) (supplied) Caution Be sure to install the media engine vertically shown as above. Installing the media engine lying flat may block ventilation, and may cause a malfunction. Note Grasp the plug when connecting the cable. 8