Sony SNC-RZ50N User Guide - Page 112
Using the SNMP, 1. Inquiry Commands, 2. Setting Commands - management software
UPC - 027242240377
View all Sony SNC-RZ50N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 112 highlights
Others Using the SNMP This unit supports SNMP (Simple Network Management Protocol). You can read MIB-2 objects using software such as SNMP manager software. This unit also supports the coldStart trap which occurs when the power is turned on or the unit restarts, and the Authentication failure trap which informs of an illegal access using SNMP. Using CGI commands, you can set community name and access limitation, host to send traps, and some MIB2 objects. To allow these settings, you need authentication by the camera administrator. 1. Inquiry Commands You can check the SNMP Agent settings using the following CGI commands. GET, POST (JavaScript parameter format) (standard format) With the above inquiry, you can obtain the following setting information. The following explains the setting information using the inqjs=snmp (JavaScript parameter) format. var sysDescr="SNC-RZ50" ...1 var sysObjectID="1.3.6.1.4.1.122.8501" ...2 var sysLocation="" ...3 var sysContact="" ...4 var sysName="" ...5 var snmpEnableAuthenTraps="1" ...6 var community="public,0.0.0.0,read,1" ...7 var community="private,192.168.0.101,read,2" ...8 var trap="public,192.168.0.101.1" ...9 1 describes the case of "mib-2.system. sysDescr.0". You cannot change this parameter. 2 describes the case of "mib-2.system. sysObjectID.0". You cannot change this parameter. 3 describes the case of "mib-2.system. sysLocation.0". This field is used to describe information on the location of this camera. Nothing is set at the factory. 4 describes the case of "mib-2.system. sysContact.0". This field is used to describe the information on administrator of this camera. Nothing is set at the factory. 5 describes the case of "mib-2.system. sysName.0". This field is used to describe administration node of this camera. Nothing is set at the factory. 6 describes the case of "mib-2.snmpEnable AuthenTraps.0". This example shows when "1" (enable) is set. With this setting, a trap occurs when there is an Authentication failure. When "2" (disable) is set, no Authentication failure trap occurs. 7 describes the community attributes. This example shows the identification number "ID=1", the community name public, and enables read from any IP address (0.0.0.0). 8 describes the community attributes, similarly to 7. This example shows the identification number ID=2, the community name "private", and enables "read" by the SNMP request packet from the host "192.168.0.101". 9 describes the attributes to send a trap. This example shows the identification number "ID=1", the community name "public", and enables sending of traps to the host having the IP address "192.168.0.101". 2. Setting Commands The unit supports the following setting commands of SNMP. GET, POST First, perform the settings of the following parameters. 1) sysLocation= Set the case of "mib-2.system.sysLocation.0" in the position. The maximum length of is 255 characters. 2) sysContact= Set the case of "mib-2.system.sysContact.0" in the position. The maximum length of is 255 characters. 112 Using the SNMP