Sony STR-DH770 Operating Instructions - Page 39
Specifications, AUDIO POWER SPECIFICATIONS - watts
View all Sony STR-DH770 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Additional Information Sony shall not be held liable in any way for damages or other loss resulting from information leaks during communication using BLUETOOTH technology. BLUETOOTH communication is not necessarily guaranteed with all BLUETOOTH devices that have the same profile as this receiver. BLUETOOTH devices connected with this receiver must comply with the BLUETOOTH specification prescribed by the Bluetooth SIG, Inc., and must be certified to comply. However, even when a device complies with the BLUETOOTH specification, there may be cases where the characteristics or specifications of the BLUETOOTH device make it impossible to connect, or may result in different control methods, display or operation. Noise may occur or the audio may cut off depending on the BLUETOOTH device connected with this receiver, the communications environment, or surrounding conditions. If you have any questions or problems concerning your receiver, please consult your nearest Sony dealer. Specifications AUDIO POWER SPECIFICATIONS POWER OUTPUT AND TOTAL HARMONIC DISTORTION: (USA models only) With 6 ohm loads, both channels driven, from 20 Hz - 20,000 Hz; rated 90 watts per channel minimum RMS power, with no more than 0.09% total harmonic distortion from 250 milliwatts to rated output. Amplifier section1) Minimum RMS Output Power (6 ohms, 20 Hz - 20 kHz, THD 0.09%) 90 W + 90 W Stereo Mode Output Power (6 ohms, 1 kHz, THD 1%) 105 W + 105 W Surround Mode Output Power2) (6 ohms, 1 kHz, THD 0.9%) 145 W per channel 1) Measured under the following conditions: Area Power requirements USA, Canada, Taiwan 120 V AC, 60 Hz Oceania, Europe 230 V AC, 50 Hz 2) Reference power output for front, center, surround, surround back and front high speakers. Depending on the sound field settings and the source, there may be no sound output. Frequency response Analog 10 Hz - 100 kHz, +0.5/-2 dB (with sound field and equalizer bypassed) Input Analog Sensitivity: 500 mV/50 kilohms S/N3): 105 dB (A, 500 mV4)) Digital (Coaxial) Impedance: 75 ohms S/N: 100 dB (A, 20 kHz LPF) Digital (Optical) S/N: 100 dB (A, 20 kHz LPF) Output (Analog) SUBWOOFER Voltage: 2 V/1 kilohm Equalizer Gain levels ±10 dB, 1 dB step 3) INPUT SHORT (with sound field and equalizer bypassed). 4) Weighted network, input level. FM tuner section Tuning range USA and Canadian models: 87.5 MHz - 108.0 MHz (100 kHz step) Other models: 87.5 MHz - 108.0 MHz (50 kHz step) Antenna (aerial) FM wire antenna (aerial) Antenna (aerial) terminals 75 ohms, unbalanced Video section Inputs/Outputs Video: 1 Vp-p, 75 ohms 39GB