Sony UPDR80 Operating Instructions - Page 10

Operation Note Do not turn the selector beyond the range of the paper size marks when setting it. Doing so may result in damage. 5 Insert the paper holders into the paper roll. A pink paper holder and a blue paper holder are provided with the printer. Insert these paper holders into the ends of the paper roll as shown in the figure below, with the pink paper holder in the end closer to the pink adhesive label and the blue paper holder in the end closer to the blue label. Label (blue) Label (pink) Paper holder (blue) Paper holder (pink) Notes • If the edges of the paper on the ends of the paper roll are not even, it is necessary to make the edges even (being careful not to crumple the edges while doing so) before placing the paper roll in the media tray. Using a paper roll with uneven edges can cause a malfunction. 1 As shown in the figure below, put the selector in the bobbin, line up the V mark on the selector with the arrow on the bobbin, and then push the selector into place. The hook on the selector snaps into the notch on the bobbin marked by the arrow. Bobbin Selector Note There are two hooks on the selector: one indicated by the V mark and the other on the opposite side of the selector. Do not install the selector so that the hook on the side opposite of the V mark is in the notch on the bobbin marked by the arrow, as doing so could result in damage to the paper holder. 2 Turn the selector in the direction indicated by the arrow in the figure below until it clicks into place. • Do not strike or squeeze the paper roll. Doing so could break or bend the paper roll, and could result in poor printing quality. • If inserting the paper holder into the paper roll is difficult when loading the paper roll, squeeze the roll from both sides to restore its shape. 6 Load the paper roll in the media tray. 1 Open the media tray cover. • Correctly insert the paper holders all the way. If the paper holder selector comes off The selector could come off if you drop the blue paper holder. Follow the procedure described below to reattach the selector to the paper holder. 10 Before Printing