Sony UPDR80 Operating Instructions - Page 22

Miscellaneous Explanation of Indicators The meanings of the indicators on the printer when they are on or flashing are described below. Indicator 1 ON/ STANDBY (green) Status On Flashing CLEANING On (orange) Flashing RIBBON/ On PAPER 1) (orange) ALARM 1) On (orange) RIBBON/ On PAPER, ALARM1) PRINT (green) On Flashing Flashing slowly Possible causes and remedies The printer is turned on. The printer is entering the standby state. The cleaning ribbon is loaded. tRemove the cleaning ribbon. One of the following causes. • Thermal head or roller cleaning is in progress. • The printer is waiting to begin roller cleaning. tPress the STOP button to begin. One of the following causes. • A paper roll has not been loaded. t Load a paper roll (page 10). • An ink ribbon has not been loaded. tLoad an ink ribbon (page 9). • The ink ribbon has been used up. tLoad a new ink ribbon and paper roll (page 12). • A ribbon error has occurred. tCheck that an ink ribbon has been loaded properly. • The paper roll is the wrong size. tSet the paper holder selector properly (page 9). One of the following causes. • The media tray is not closed. tClose the media tray properly. • A paper jam has occurred in the printer. tRemove the jammed paper (page 23). • The paper outlet is full of printouts. tRemove the printouts that are blocking the paper outlet. • The paper cover is not attached. tInsert the paper cover fully and attach it securely. One of the following causes. • The paper roll has run out. tLoad a new ink ribbon and paper roll (page 12). • A paper feed error has occurred. tCheck the ink ribbon and paper roll. • A paper eject error has occurred. tCheck the ink ribbon and paper roll. Printing is in progress. Image data is being received. The printer is waiting until the thermal head reaches a temperature at which printing is possible. Once that temperature is reached, the PRINT indicator will light. Indicator Status Possible causes and remedies All of On CLEANING, RIBBON/ PAPER, ALARM, and PRINT • The printer is initializing. tAfter pressing the 1 ON/ STANDBY switch to turn on the printer, this indicator remains lit while the printer is initializing. Wait until initialization is complete. • The media tray was opened during printing. tPress the 1 ON/STANDBY switch to enter the standby state, press the 1 ON/STANDBY switch again to turn on the power, and then check the ink ribbon and paper roll. • A serious failure has occurred. tPress the 1 ON/STANDBY switch to enter the standby state, and then press the 1 ON/ STANDBY switch again to turn on the power. If the printer is still unable to recover from the failure, press the 1 ON/ STANDBY switch to enter the standby state and then disconnect the power cord and contact your dealer. CLEANING/ On ALARM One of the following causes. • The receptacle for scraps that are cut off during printing is full. tEmpty the scrap receptacle (page 14). • A ribbon error occurred while cleaning was in progress. tCheck that the cleaning ribbon has been loaded properly. • A paper jam occurred inside the printer while cleaning was in progress. tRemove the jammed paper (page 23). • The paper roll ran out while cleaning was in progress. tLoad a new paper roll. • A feed error occurred while cleaning was in progress. tCheck the cleaning ribbon and paper roll. • An eject error occurred while cleaning was in progress. tCheck the cleaning ribbon and paper roll. 1) During continuous printing, the PRINT indicator lights at the same time if there are still images remaining. 22 Explanation of Indicators