Sony VPL-DX100 Operating Instructions - Page 26

Messages List When any of the messages listed below appears on the projected image, address the problem in accordance with the table below. Messages Meaning/Remedy High temp.! Lamp off in 1 min. Check the items below. • Check if nothing is blocking the ventilation holes. • Check if the air filter is not clogged. • Check if the Installation Attitude in the Installation menu is set correctly. Frequency is out of range! Change the output setting of the connected equipment to one for signals supported by the projector. Please check Input-A Signal Sel. Set "Input-A Signal Sel." to "Auto" or select the input signal type to suit to the input signal. Please clean the filter. Clean the air filter. Please replace the Lamp Replace the lamp with a new one and clean the air filter. The and clean the Filter. message appears whenever you turn on the power until you replace the lamp and reset the lamp timer. Not applicable! Invalid key was pressed. The control keys are locked! "Control Key Lock" is set to "On." Projector will shutdown The ?/1 key was pressed and the projector will be shut down soon soon. To cancel shutdown, press the ?/1 key again (the Press ?/1 Key to Restart projector will remain on). To turn off the projector directly, press and hold the ?/1 key for a few seconds. Lamp Dimming Reduces lamp output when "With Static Signal" is set. When any change in signal is detected, or an operation (remote control or control panel) is performed, normal brightness is restored. Page 3, 3, 23, 31 36 22 31 29, 31 - 21 13 22 26 Messages List