Stihl 009 Instruction Manual - Page 28

On Quickstop

Get Stihl 009 PDF manuals and user guides View all Stihl 009 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 28 highlights

Locating the guide bar Top: Center: Bottom: Fitting the chain Peg in fixing hole cutting edges point toward bar nose Drive link tang 125BA005 LA 125BA004 LA 125BA006 LA 76 79 8 Starting at the chain sprocket , place the Oilomatic chain on the guide bar so that the cutting edges on the top of the bar point toward the bar nose . Now pull the guide bar forwards until the peg of the tensioning nut engages the lower fixing hole . The bar should now fit against the housing. Now tension the chain by turning the tensioning screw clockwise until the chain sags only slightly at the bottom of the bar. Make sure that the drive link tangs are located in the bar groove. 4 Refit the sprocket cover , making sure that the rear of the sprocket cover locates in the housing seat below the rear handle as you push it over the stud bolt . On Quickstop models the chain brake must be disengaged and the top end of the lever (11) must be located in the slot in the hand guard . 10 125BA007 LA

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
Locating the guide bar
Top:
Fitting the chain
Center:
Peg in fixing hole -
cutting edges point toward bar nose
Bottom:
Drive link tang
125BA006 LA
4
79
8
125BA005 LA
7
6
125BA004 LA
10
125BA007 LA
Starting at the chain sprocket
²º´
, place the Oilomatic chain
on the guide bar so that the cutting edges on the top of the
bar point toward the bar nose
²»´
. Now pull the guide bar
forwards until the peg of the tensioning nut
²·´
engages the
lower fixing hole
²¼´
. The bar should now fit against the
housing.
Now tension the chain by turning the tensioning screw
²¸´
clockwise until the chain sags only slightly at the bottom of
the bar. Make sure that the drive link tangs
²³½´
are located
in the bar groove.
Refit the sprocket cover
²¶´
, making sure that the rear of the
sprocket cover locates in the housing seat below the rear
handle as you push it over the stud bolt
²¹´
. On Quickstop
models the chain brake must be disengaged and the top
end of the lever (11) must be located in the slot in the hand
guard
²³µ´
.
µ¹