Stihl 036 Instruction Manual - Page 46
&khfnlqj´dqg´5hsodflqj, &kdlq´6surfnhw
![]() |
View all Stihl 036 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
- or even sooner if the wear marks on the sprocket are deeper than approx. 0.5 mm (1/64") since this would reduce the life of the chain. Check wear marks: Left: on webs of rim sprockets Right: on teeth of spur sprockets. You can use gauge * 0000 893 4101 to check the depth of the wear marks on spur and rim sprockets. *Special accessory It is best to use two chains in rotation with one sprocket. • Remove chain sprocket cover, • chain and guide bar. Disengage the chain brake: Pull hand guard toward front handle Use a screwdriver to remove the E-clip. •• Take off the washer and rim sprocket. Examine splines on clutch drum if wear marks are severe, fit a new clutch drum: Pull clutch drum and needle cage off the crankshaft clean the crankshaft stub and needle cage, and lubricate with STIHL grease (tube 0781 120 1111). Reassemble with new rim sprocket and new clutch drum, if necessary - • fit rim sprocket with cavities facing outward refit washer and •• E-clip on the crankshaft. Use only original STIHL clutch drums to ensure correct operation of the chain brake. • Use a screwdriver to remove the E-clip. • Pull washer, spur sprocket and • needle cage off the crankshaft. Clean the crankshaft stub and needle cage, and lubricate with STIHL grease (tube 0781 120 1111). • Reassemble with new spur sprocket After fitting the clutch drum, rotate it about one half turn to engage oil pump drive. Refit washer and E-clip on the crankshaft. Use only original STIHL chain sprockets to ensure correct operation of the chain brake. K
![](/manual_guide/products/stihl-036-instruction-manual-2f6142a/46.png)