Stihl 036 Instruction Manual - Page 51
Shflilfdwlrqv
View all Stihl 036 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
STIHL single cylinder two-stroke engine Displacement: 61.5 cm3 (3.75 cu.in) Bore: 48 mm (1.89 in) Stroke: 34 mm (1.34 in) Idle speed: 2,500 r.p.m. Maximum engine speed (cut-off speed): 13,500 rpm Fuel tank capacitiy: 0.625 l (1.32 US pt) Fuel mixture: see chapter "Fuel" Chain lubrication: Fully automatic, speed-controlled reciprocating oil pump. Additional manual oil flow control Oil tank capacity: 0.32 l (0.68 US pt) Type: Electronic magneto ignition (breakerless) Ignition timing: 1.9 - 2.5 mm (0.075 - 0.1 in) B.T.D.C. at 8,000 r.p.m. Spark plug (suppressed): Bosch WSR 6 F or NGK BPMR 7 A; Electrode gap 0.5 mm (0.02 in) Spark plug thread M 14x1.25, 9.5 mm (0.37 in) long Carburetor: All position diaphragm carburetor with integral fuel pump Air filter: Prefilter and bisectional box filter without bar and chain 5.7 kg (12.6 lb) Recommended cutting attachments for compliance with § 5.12 of ANSI Standard B 175.1-1991 (see page 11 of this Manual): STIHL reduced kickback bar (with green label): for 0.325" and 3/8" pitch: Rollomatic with sprocket nose 40, 45 or 50 cm (16, 18 or 20 in) STIHL low kickback chain* (with green label): 8.25 mm (0.325") Rapid-Micro 2 (26 RM 2) 9.32 mm (3/8") Rapid-Micro 2 (33 RM 2, 36 RM 2) Chain sprocket: 8-tooth for 0.325" pitch or 7-tooth for 3/8" pitch Since new bar/chain combinations may be developed after publication of this Manual, ask your STIHL dealer for the latest STIHL recommendations. Other bars and chains available for this powerhead are: STIHL yellow-labeled bars: for 0.325" and 3/8" pitch: Rollomatic "S" with sprocket nose 40, 45, 50 cm (16, 18, 20 in) 60 cm (24 in) 3/8" pitch only Duromatic with stellite tipped nose 40, 45, 50 cm (16, 18, 20 in) 60 cm (24 in) 3/8" pitch only STIHL yellow -labeled chains: for 0.325" pitch: Rapid-Super (26 RS), Rapid-Micro (26 RM) for 3/8" pitch: Rapid-Micro (33 RM, 36 RM), Rapid-Super (33 RS, 36 RS, 33 RSL, Rapid-Duro 33 RD). In order to comply with the kickback performance requirements of § 5.12 of ANSI Standard B 175.1-1991, do not use replacement saw chain unless it has been designated as meeting the ANSI § 5.12 requirements on this specific powerhead, or has been designated as "low kickback" saw chain* in accordance with the ANSI B 175.1-1991 standard. *See definition of "low kickback chain" on page 15 of this Manual.