Home » Stihl Manuals » Lawn & Garden » Stihl BG 45 » Manual Viewer

Stihl BG 45 Instruction Manual - Page 25

Troubleshooting Guide

Get Stihl BG 45 PDF manuals and user guides

Add to My Manuals
Save this manual to your list of manuals

Page 25 highlights

22 Troubleshooting Guide 22 Troubleshooting Guide English 22.1 Troubleshooting Always remove the activation key before carrying out any inspection, cleaning or maintenance. Condition LEDs on the blower 3 LEDs flash red. Blower does not start when switched on. 1 LED flashes green. 3 LEDs glow red. Blower cuts out during operation. 3 LEDs glow red. Run-time is too short. Cause Remedy Malfunction in blower. ► Do not attempt to use. The blower has a malfunction and must be checked by a servicing dealer. Activation key not fully inserted. ► Remove the activation key, @ 13.2. ► Visually check the electrical contacts of the activation key. ► Reinsert the activation key, @ 13.1. Less than 20 % ► Charge the blower, @ 10. charge remaining. Integrated battery too hot. ► Remove the activation key, @ 13.2. ► Allow the blower to cool down gradually at ambient temperatures of about 50 °F to 68 °F (10 °C to 20 °C). Moisture in blower. ► Allow the blower to dry. Integrated battery too hot. ► Remove the activation key, @ 13.2. ► Allow the blower to cool down gradually at ambient temperatures of about 50 °F to 68 °F (10 °C to 20 °C). Electrical malfunction. ► Switch off the blower. Wait at least 5 seconds and switch it back on, @ 14. Blower not fully charged. ► Charge the blower, @ 10. Useful life of ► Have the blower checked by an authorized STIHL servicing integrated battery dealer. has been reached or exceeded. Integrated battery too hot / too cold. ► Allow the blower to warm up or cool down gradually at ambient temperatures of about 50 °F to 68 °F (10 °C to 20 °C). Blower is not being 3 LEDs glow charged. red. Integrated battery too hot / too cold. ► Allow the blower to warm up or cool down gradually at ambient temperatures of about 50 °F to 68 °F (10 °C to 20 °C). ► Operate the charger only in enclosed, dry rooms at ambient temperatures of 32 °F to 104 °F (0 °C to 40 °C). 0458-719-8621-A 23

Section	Page
1 Introduction	4
2 Guide to Using this Manual	4
2.1 Signal Words	4
2.2 Symbols in Text	5
3 Main Parts	5
3.1 Blower and Charger	5
4 Safety Symbols on the Products	6
4.1 Blower and Charger	6
5 IMPORTANT SAFETY INSTRUCTIONS	7
5.1 Introduction	7
5.2 Intended Use	7
5.3 Operator	7
5.4 Personal Protective Equipment	8
5.5 Blower	8
5.6 Integrated Battery	9
5.7 Using the Blower	11
5.7.1 Before Operation	11
5.7.2 Holding and Controlling the Blower	11
5.7.3 Working Conditions	12
5.7.4 Operating Instructions	13
6 Charger Safety	14
6.1 Warnings and Instructions	14
7 Maintenance, Repair and Storage	15
7.1 Warnings and Instructions	15
8 General Warnings and Instructions	16
8.1 General Safety Warnings and Instructions for Battery-Powered Products	16
9 Before Starting Work	17
9.1 Preparing the Blower for Operation	17
10 Charging the Blower	17
10.1 Charging	17
11 LED Diagnostics	18
11.1 Blower Status	18
11.2 Charge Status	18
12 Assembling the Blower	18
12.1 Mounting the Blower Tube and Nozzle	18
13 Inserting and Removing the Activation Key	19
13.1 Inserting the Activation Key	19
13.2 Removing the Activation Key	19
14 Switching the Blower On and Off	20
14.1 Switching On	20
14.2 Switching Off	20
15 Checking the Controls	20
15.1 Testing the Controls	20
16 During Operation	21
16.1 Using the Blower	21
17 After Finishing Work	22
17.1 Preparing for Transportation or Storage	22
18 Transporting the Blower	22
18.1 Blower	22
19 Storing the Blower and Charger	22
19.1 Blower	22
19.2 Charger	23
20 Cleaning	23
20.1 Cleaning the Blower and Charger	23
21 Inspection and Maintenance	23
21.1 Inspecting and Maintaining the Blower	23
22 Troubleshooting Guide	25
22.1 Troubleshooting	25
23 Specifications	26
23.1 STIHL BGA 45	26
23.2 STIHL LK 45	26
23.3 Symbols on the Blower and Charger	26
23.4 Engineering Improvements	27
23.5 FCC 15 Compliance Statement	27
24 Replacement Parts and Equipment	27
24.1 Genuine STIHL Replacement Parts	27
25 Disposal	27
25.1 Disposal of the Blower and Charger	27
26 Limited Warranty	28
26.1 STIHL Incorporated Limited Warranty Policy	28
27 Trademarks	28
27.1 Registered Trademarks	28
27.2 Common Law Trademarks	28
28 Addresses	29
28.1 STIHL Incorporated	29
1 Introducción	31
2 Acerca de este manual de instrucciones	31
2.1 Palabras identificadoras	31
2.2 Símbolos en el texto	32
3 Componentes importantes	32
3.1 Soplador y cargador	32
4 Símbolos de seguridad en los productos	33
4.1 Soplador y cargador	33
5 INSTRUCCIONES IMPORTANTES DE SEGURIDAD	34
5.1 Introducción	34
5.2 Uso previsto	34
5.3 Operador	35
5.4 Equipos de protección personal	35
5.5 Soplador	36
5.6 Batería integrada	37
5.7 Uso del soplador	38
5.7.1 Antes de usar	38
5.7.2 Sujeción y control del soplador	39
5.7.3 Condiciones de trabajo	40
5.7.4 Instrucciones de manejo	41
6 Seguridad del cargador	42
6.1 Advertencias e instrucciones	42
7 Mantenimiento, reparación y almacenamiento	44
7.1 Advertencias e instrucciones	44
8 Advertencias e instrucciones generales	45
8.1 Instrucciones y advertencias de seguridad generales para productos alimentados por batería	45
9 Antes de empezar a trabajar	46
9.1 Preparación del soplador para el funcionamiento	46
10 Carga del soplador	46
10.1 Carga	46
11 Diagnóstico de LED	47
11.1 Estado del soplador	47
11.2 Estado de carga	47
12 Armado del soplador	47
12.1 Instalación del tubo y la boquilla de soplador	47
13 Inserción y retiro de la llave de activación	48
13.1 Inserción de la llave de activación	48
13.2 Retiro de la llave de activación	48
14 Encendido y apagado del soplador	49
14.1 Encendido	49
14.2 Apagado	49
15 Revisión de los controles	49
15.1 Prueba de los controles	49
16 Durante el funcionamiento	50
16.1 Uso del soplador	50
17 Después de completar el trabajo	51
17.1 Preparación para el transporte o el almacenamiento	51
18 Transporte del soplador	51
18.1 Soplador	51
19 Almacenamiento del soplador y el cargador	52
19.1 Soplador	52
19.2 Cargador	52
20 Limpieza	52
20.1 Limpieza del soplador y del cargador	52
21 Inspección y mantenimiento	53
21.1 Inspección y mantenimiento del soplador	53
22 Guía de solución de problemas	54
22.1 Localización de averías	54
23 Especificaciones	56
23.1 STIHL BGA 45	56
23.2 STIHL LK 45	56
23.3 Símbolos en el soplador y el cargador	56
23.4 Mejoramientos técnicos	57
23.5 Declaración de cumplimiento con norma FCC 15	57
24 Piezas y equipos de repuesto	57
24.1 Piezas de repuesto originales de STIHL	57
25 Eliminación	57
25.1 Eliminación del soplador y el cargador	57
26 Garantía limitada	58
26.1 Política de garantía limitada de STIHL Incorporated	58
27 Marcas comerciales	58
27.1 Marcas comerciales registradas	58
27.2 Marcas comerciales por ley común	58
28 Direcciones	59

Match case Limit results 1 per page

0458-719-8621-A

English

22 Troubleshooting Guide

22.1

Troubleshooting

Troubleshooting Guide

Always remove the activation key before carrying out any inspection, cleaning or maintenance.

Condition

LEDs on the

blower

Cause

Remedy

3 LEDs flash

red.

Malfunction in

blower.

►

Do not attempt to use. The blower has a malfunction and

must be checked by a servicing dealer.

Blower does not start

when switched on.

Activation key not

fully inserted.

►

Remove the activation key,

13.2.

►

Visually check the electrical contacts of the activation key.

►

Reinsert the activation key,

13.1.

1 LED flashes

green.

Less than 20 %

charge remaining.

►

Charge the blower,

10.

3 LEDs glow

red.

Integrated battery

too hot.

►

Remove the activation key,

13.2.

►

Allow the blower to cool down gradually at ambient

temperatures of about 50 °F to 68 °F (10 °C to 20 °C).

Moisture in blower.

►

Allow the blower to dry.

Blower cuts out

during operation.

3 LEDs glow

red.

Integrated battery

too hot.

►

Remove the activation key,

13.2.

►

Allow the blower to cool down gradually at ambient

temperatures of about 50 °F to 68 °F (10 °C to 20 °C).

Electrical

malfunction.

►

Switch off the blower. Wait at least 5 seconds and switch it

back on,

14.

Run-time is too short.

Blower not fully

charged.

►

Charge the blower,

10.

Useful life of

integrated battery

has been reached or

exceeded.

►

Have the blower checked by an authorized STIHL servicing

dealer.

Integrated battery

too hot / too cold.

►

Allow the blower to warm up or cool down gradually at

ambient temperatures of about 50 °F to 68 °F (10 °C to

20 °C).

Blower is not being

charged.

3 LEDs glow

red.

Integrated battery

too hot / too cold.

►

Allow the blower to warm up or cool down gradually at

ambient temperatures of about 50 °F to 68 °F (10 °C to

20 °C).

►

Operate the charger only in enclosed, dry rooms at ambient

temperatures of 32 °F to 104 °F (0 °C to 40 °C).