Sub-Zero 427 Wine Storage Installation Instructions - Page 21
Models 427G and 427RG Installation, Unpack the Unit - wine storage 427rg
View all Sub-Zero 427 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Models 427G and 427RG Installation 21 subzero.com Unpack the Unit Before moving the wine storage unit into position, secure the door closed, remove drawers (427RG) and protect any finished flooring. Uncrate the wine storage unit and inspect for any damage. Remove the wood base and discard the shipping bolts that hold the wood base to the bottom of the unit. Remove all packing materials and tape. All roller-assembly wine shelves should be removed to reduce weight and prevent them from rolling. To remove, pull the shelf out to its full extension, gently and evenly lift up on both sides of the front of the shelf and remove. Reverse the procedure to reinstall the shelf. For model 427RG, the drawers should be removed and placed aside until you are ready for installation of the panels. Remove the decorative top and side moldings and the kickplate/grille. IMPORTANT NOTE: For model 427RG, the top drawer has a control cable that needs to be disconnected before removing this drawer. Refer to the illustration below for placement and how to disconnect this fitting. DUAL INSTALLATIONS When two model 427G, 427RG or integrated units are installed closer than 2" (51) to one another, it is necessary to use the dual installation heater kit. The heater from this kit must be attached to the left side exterior of the righthand unit before the unit is slid into position. The dual installation heater kit and additional instructions is available through your authorized Sub-Zero dealer, or call Sub-Zero customer care at 800-222-7820. You can also visit our website at subzero.com. LOCK INSTALLATION For models 427G and 427RG, the optional lock is attached to the decorative door panel through a fielddrilled hole in the panel. The catch should be installed on the top of appliance cabinet before the unit is moved into position. The accessory lock kit and additional instructions are available through your authorized Sub-Zero dealer, or call Sub-Zero customer care at 800-222-7820. You can also visit our website at subzero.com. IMPORTANT NOTE: For accessory stainless steel panels requiring a lock, panels must be ordered with the lock mounting hole pre-drilled. Control cable.