Sub-Zero 427 Wine Storage Installation Instructions - Page 52
Model WS-30 Installation, Flush Inset Panels-Dual Installation
View all Sub-Zero 427 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Model WS-30 Installation 52 Flush Inset Panels-Dual Installation When installing two models WS-30 or a model WS-30 and built-in unit side by side in a flush inset application, you must decrease the width of the decorative flush inset panels by 1/2" (13). Adjustments to the panel offsets will also need to be made. These adjustments are needed to achieve a proper fit and to ensure the panels do not collide when closing. Panel dimensions in the chart below have been adjusted to reflect the decrease in panel dimensions. IMPORTANT NOTE: If a filler strip is not used, dual installations can only be accomplished using two units with opposite hinges. Illustrations A-E provide panel offsets and reveals for model WS-30 in a flush inset application. Refer to the chart below for reference to the illustrations. All reveals are 1/2" (13) unless otherwise specified. For additional information on panel reveals, visit the specification library section of our website, subzerotrade.com. TOP VIEW DOOR / DRAWER / GRILLE BACKER SPACER CABINETRY DOOR TOP VIEW DUAL TRIM DOOR FLUSH INSET PANEL 5/16" (8) 1/2" (13) 5/8" (16) 5/16" (8) 1/8" (3) 1/4" (6) REVEAL Illus. A Illus. B CABINETRY 1/2" (13) GRILLE 1/8" 5/16" (3) (8) GRILLE 5/16" (8) 5/32" (4) 1/2" (13) Do not exceed the flush inset decorative panel dimensions. Exceeding dimensions could cause damage to SIDE VIEW DOOR 3/32" 5/16" (2) (8) SIDE VIEW S the panels and the Sub-Zero unit. Illus. C Illus. D Panel Offsets WS-30 Doors (hinge) / Grille Sides Doors (handle) Sides Grille Top Grille Bottom / Door Top Door Bottom Illus. A B C D E DOOR / S DRAWER 5/16" (8) SIDE VIEW 3/32" (2) Illus. E S 5