Sub-Zero 427R Wine Storage Use & Care - Page 17
Condenser Cleaning
View all Sub-Zero 427R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Wine Storage Use & Care 17 subzero.com Cleaning CONDENSER CLEANING Clean the condenser area every three to six months. The cleaning schedule will depend on the amount of dust and lint that accumulates in this area. For models 424G and 424FSG, the condenser is located behind the kickplate. Remove the kickplate to expose the condenser area. Refer to the illustration below. The condenser for models 427G and 427RG is located behind the kickplate/grille. Remove the screws holding the kickplate/grille. This assembly will slide forward easily, giving you access to the condenser area. Refer to the illustration below. For model WS-30, the condenser is located behind the grille. Pull out on the bottom edge of the grill and tilt forward for access to the condenser area. Refer to the illustration. Using a soft bristle brush, vacuum to remove dust and lint from the condenser area. IMPORTANT NOTE: To avoid bending the condenser fins, be sure to vacuum in the direction of the fins (up and down). Before cleaning the condenser, shut off power to the unit at the control panel. Wear gloves to avoid injury from sharp condenser fins. Failure to clean the condenser could result in temperature loss or mechanical failure or damage. CONDENSER Location of condenser (WS-30). CONDENSER CONDENSER Location of condenser (424G and 424FSG). Location of condenser (427G and 427RG).