Sub-Zero IC-30FI Integrated Installation Guide - Page 13

PANEL INSTALLATION Panel Installation DRAWER PANEL INSTALLATION Place the panel face down on a protected work surface. Position the template flush with the top and sides of the panel. Verify the correct side of the template is being used, then mark and drill holes. Refer to the illustration below. Use the T-20 torx drive provided, to partially insert a #8 x 1/2" screw into the second hole from the top on each side of the panel. The screws should be approximately 3/16" (4) proud of the panel and will support the weight of the panel during installation. Align the support screws on the back of the panel with the slotted holes on both drawer mounting brackets. Refer to the illustration below. Opening the drawer slightly may help with alignment. Once the panel is supported by the screws, partially insert a #8 x 1/2" screw into the second hole from the bottom on each side of the panel, but do not tighten. PANEL ADJUSTMENT Close the door and/or drawers, now adjustments can be made to align panels and reveals. For side-to-side adjustment, move panels side to side, then install and tighten all mounting screws. For up-and-down and in-and-out adjustments, slightly loosen the bracket screws. Depending on the level of adjustment required, it may be helpful to loosen all of the bracket screws which will allow for maximum adjustment. Once the bracket screws are loosened, rotate the cams to make adjustments. After adjustments have been made, tighten all bracket screws. Refer to the illustrations below. TOP OF DRAWER PANEL TOP OF DRAWER PANEL TOP HOLES FOR UPPER AND LOWER DRAWERS BACK OF DRAWER PANEL BRACKET SCREWS IN-AND-OUT CAM BRACKET SCREWS UP-AND-DOWN CAM In-and-out adjustment. Up-and-down adjustment. OF DRAWER PANEL LEFT EDGE OF DRA Drawer panel template-top. Drawer panel mounting. subzero.com | 13