Symphonic CSHP80G Owner's Manual - Page 13

BeforeYou Start Functional Overview (Cont'd) Before You Start Connections DVR DVD Installing batteries in the remote control Install two AA-size batteries (supplied), matching their polarity to those indicated inside the battery compartment of the remote control. 1 2 3 Battery use and care Incorrect use of batteries can result in hazards such as leakage and bursting. Please follow the instruction below: • Do not mix new and old batteries together. • Do not use different kinds of batteries together. Although they may look similar, different batteries may have different voltages. • Make sure that the plus and minus ends of each battery match the indications in the battery compartment. • Remove batteries from equipment that is not going to be used for a month or more. • When disposing of used batteries, please comply with governmental regulations or public rules for environmental protection that apply in your country or area. • Do not recharge, short-circuit, heat, burn or disassemble batteries. Using a remote control Keep in mind the following when using the remote control: • Make sure that there is no obstacle between the remote control and the remote sensor of the unit. • Remote operation may become unreliable if strong sunlight or fluorescent light shines on the remote sensor of the unit. • Remote control for different devices can interfere with each other. Avoid using remote controls for other equipment located close to the unit. • Replace the batteries when you notice a fall-off of the operating range of the remote control. • The maximum operable ranges (approximate) from the unit are as follows. - Straight line: 23 feet (7 m) - Either side of center: 16 feet (5 m) within 30° - Above: 16 feet (5 m) within 15° - Below: 10 feet (3 m) within 30° 16feet (5m) (15°) IR signal check Use the AM radio or the digital camera to check if the remote control properly sends out the infrared signal. It will help to define the cause of malfunction. Using AM radio Tune the AM radio to no broadcasting band. Press any button on the remote control toward the radio. If the radio receives the signal from the remote control properly, the sound will flutter. Using digital camera (including built-in camera of cellular phone) Press and hold any button on the remote control toward a digital camera.The remote control is working if you confirm infrared light through the digital camera. Switching DVR / DVD Because this product is a combination of a DVR and DVD Player, you must select first which component you wish to operate. DVR mode Press DVR on the remote control. (Verify that the DVR indicator is lit.) DVD mode Press DVD on the remote control. (Verify that the DVD indicator is lit.) Device Select button POWER DVR REC/OTR PAUSE STOP PLAY DVD CHANNEL DVR DVD OPEN/CLOSE DVD button DVR button DVD indicator DVR indicator TIMER POWER SET UP PROG. OPEN/CLOSE 1 2 3 CHANNEL 4 5 6 PROGRAM RECORDINGS 7 8 9 CLEAR 0 +10 MODE ZOOM SUB TITLE ANGLE AUDIO MENU TOP MENU DISPLAY ENTER RETURN SKIP DVR DVD SKIP REV PLAY FWD REC/OTR STOP PAUSE SEARCH REPEAT A-B POWER DVR REC/OTR PAUSE STOP PLAY DVD CHANNEL OPEN/CLOSE 16feet (5m) (30°) 23feet (7m) 10feet (3m) (30°) 16feet (5m) (30°) EN 13 Others